Product Manual
Table Of Contents
- Nikon N Series/K Series Total Station Instruction Manual
- Legal Notices
- Safety
- Introduction
- Preparation
- Unpacking and Packing the Instrument
- Charging the Battery Pack
- Detaching and Re-Attaching the Battery Pack
- Setting Up the Tripod
- Centering
- Leveling
- Sighting
- Setting the Measurement Mode and Preparing the Target
- Measurement in Reflectorless Mode (N 2" and N 5" only)
- Setting Up the Prism Reflector
- Face-1/Face-2 Measurement
- External Device Connector
- Getting Started
- Applications
- HA Reset and Angle Operations
- Station Setup
- Setting up a station with known coordinates or azimuth
- Setting up a station using multiple point resection
- Setting up the station quickly without coordinates
- Determining station elevation
- Checking and resetting the backsight direction
- Base XYZ function
- Two-point resection along a known line
- Setting up a station for traverse measurement
- Use last
- Stakeout
- Program Key
- Recording Measurement Data
- Measuring Offsets
- Menu Key
- Checking and Adjustment
- System Diagrams
- Communications
- Error Messages
4 Applications
72 Nikon N Series/K Series Total Station Instruction Manual
If you selected a point from the list, the display returns
to the list, unless all points have been selected. Press
[ESC] to return to the point input screen.
Advanced feature: Specifying a stakeout list by range input
1. To input points by range, press the
Fr/To
softkey in the PT field.
2. Enter the start point (Fr) and the end point (To).
The range between Fr and To must be less than
1001 points.
If existing points are found between Fr and To, a
point list appears.
To highlight a point, press
[^] or [v]. To go to the
stakeout observation screen, press
[ENT].
If you have assigned a control job, and
additional points are found in the control job, the
Ctrl softkey appears under the list.
DivLine S-O
This function divides the line between the instrument and the first target by an input
span number. It then guides you to stake out the points, one by one.
1. Press
[3] or select DivLine S-O in the Stakeout
menu.
2. Set up the baseline. To do this, sight the target on
the line (the end point) and press
[MSR1] or [MSR2].