Operation Manual

48
Jp
En
Fr
Es
Pt
49
Jp
En
Fr
Es
Pt
External display
Measure the distance between two points
[Results]
After measuring two points, "Linear
distance to two points" and "Vertical
separation (height) and angle
between two points" are displayed.
Units can be shown in meters or
yards. Angles are indicated by
°(degree).
Linear distance (1st point)
Linear distance (2nd point)
Vertical separation (height between two points)
Angle of two points
Unit
[Measuring 1st point]
[Failed to measure 1st point]
Angle measurements never fail.
[Results of 1st point]
[Measuring 2nd point]
[Failure to measure 2nd point]
Although the point is located
downward, display shows the
upward position.
Angle measurements never fail.
[Display of results for vertical separation (height between two
points) and 2nd point]
【0 • 1 • 2】 Power On/Off and others
Operation and internal display
See the relevant section in this manual for each mode setting and display.
8
Power off
Regardless of process, after 30 seconds 30 seconds
since your last operation, power turns off. without operation
Operation/Results Work Button Display Display examples
0 Switch for FULL/Limited Perform this operation MODE
modes  whenpowerisoff. +(followby)POWER
Operation is complete (1) Initial screen
When switching to Limited mode
When the symbol (shown on right)
does not appear, Limited mode is switched
to Full mode.
After approx. two seconds, proceed to (2).
(2) Measurement standby Last use symbol
1 Power On Initial screen
POWER
All symbols
Measurement standby When this symbol (shown on right) (while pressing)
does not appear, Limited mode is set.
Measurement standby Last Use mode symbol
2 Selecting and setting (1) Linear distance【3】
n/a
Limited mode
(2) Horizontal distance【4】 MODE
n/a
(3) Height (from horizontal)【5】 MODE
n/a
(4) Angle (from horizontal)【6】 MODE
n/a
(5) Vertical separation MODE
blinks.
n/a
(height between two points)【7】
Return to 2-(1) Linear distance,
n/a
then repeat.
The angles and heights
between two points are
displayed only at the FULL
mode setting.
Linear distance, Horizontal
distance and height are
displayed when FULL/
Limited mode is set.
Initial screen (FULL mode)
Vertical separation
(height between two points)
After displaying vertical
separation (height between
two points), pressing MODE
button displays the result of
the 2nd point.