Operation Manual

56
Jp
En
Fr
Es
Pt
57
Jp
En
Fr
Es
Pt
Others
Do not use the Nikon Laser 550A S for purposes beyond the limits of its stated accuracy.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Troubleshooting/Repair
If your Nikon Laser 550A S should require repair, please contact your local dealer for details regarding where
to send it. Before doing so, you are advised to consult the Troubleshooting Table below.
Symptom Check Points
Unit does not turn
on — LCD fails to
illuminate
Target range cannot
be obtained
[- - -] (“Cannot
measure”) appears
Closer target cannot
be measured
Target beyond a
certain distance
cannot be measured
•DepressPOWERbutton.
•Checkandreplacebatteriesifnecessary.
•Besurethatnothing,suchasyourhandorfinger,is
blocking the laser emission aperture and laser detector.
•Besurethatthelaseremissionapertureandlaserdetector
are clean. Clean them if necessary.
•Besurethatthetargetshapeandconditionisappropriate
to reflect the laser beam.
•Replacebattery.
•Besuretoholdtheunitsteadywhiledepressingthe
POWER button.
•Besurethetargetiswithinmeasuringrange(10-500m/11
- 550 yards)
•Besurethatnothing,suchasleavesorgrass,isbetween
the Nikon Laser 550A S and the target.
•Besurethatnothing,suchasleavesorgrass,isbetween
the Nikon Laser 550A S and the target.