Operation Manual

33
Additional Information
E
A characteristic of electronic cameras
In rare cases, when strong static electricity or the like is
applied to the camera, the camera may not work properly.
If this happens, remove the battery and re-install it.
When the battery is removed, the date/time you set are
cleared. Reset them after reinstalling the battery.
( p. 31)
Problem
LCD panel
Ref. page
15,22
a Camera shake.
→ Gently press the Shutter Release button,
or use a tripod or place the camera on a
stable flat surface.
a Something in front or behind the subject is
in focus.
→ Be sure to center the autofocus spot
marks on the subject before releasing
the shutter. When correct focus cannot
be easily achieved, use the focus lock.
a The battery is installed the wrong way
round.
→ Install it observing the correct polarity.*
a No battery or dead battery.
→ Install a new battery.*
a The letter “ ” blinks or lights up.
→ Remove the film and load it again.
The subject
appears out
of focus in
the print.
No indicator
appears
even when
the camera
is turned on.
The numeral
“ ” does not
appear even
when film is
loaded.
Check points and solution
Focus
10,11
8
8
15,16
23,25
*
When the battery is replaced or re-installed, the date and time you set are
cleared. Reset them. ( p. 31)