Manual

239
Getting to Know Nikon Capture 4 Camera Control
The Mechanical Tab
The fol low ing settings can be ad just ed from the Me chan i cal tab:
Controls displayed when D2H is
connected
Controls displayed when D100 is
connected
Shoot ing Mode
Sets the shooting mode for D1-series cameras connected in PC mode to Single or Continu-
ous. Changes to this setting also apply to Custom Setting 30. Unless Enable controls on
the camera body is checked in the connection status area, the shooting mode for D2H cam-
eras can be selected from Single, Continuous, High-Speed Continuous, and Self-Timer.
If Continuous or High-Speed Continuous is selected, the AF and Shoot and Shoot but-
tons will instead be labeled AF and Start and Start. If Enable controls on the camera
body is checked or a D100 camera is connected, the current shooting mode will be shown,
but changes can only be made using camera controls. See the camera manual for details.
Maximum Shots (D2H only)
Use the arrows to choose the maximum number of shots that can be taken in a single burst in
continuous low-speed or continuous high-speed modes, or enter a value directly in the text
box. Choose any value between 1 and 40; the value chosen should not, however, exceed the
capacity of the camera memory buffer as shown at the right edge of the LCD display. Values
larger than the capacity of the camera memory buffer will be shown in red. This setting only
applies when the camera is connected, and differs from the number of shots selected with
Custom Setting d2.
AF Area Mode
Choose the AF-area mode. If Enable controls on the camera body is checked (D2H only),
the current AF-area mode will be shown, but changes can only be made using camera con-
trols. See the camera manual for details.
Fo cus Mode
The cur rent focus mode setting is displayed. See the cam era man u al for details. This set ting
can not be changed from Nikon Cap ture.