Instruction Manual

12
En
13
En
Note:
• The windage and elevation scales of the PROSTAFF 5 Riflescope 3.5-14×40 SF, 3.5-14×50 SF, and 4.5-18×40 SF are calibrated in divisions of 1/4 minute of angle with a click at intervals of 1/4 minute of angle
(1 division).
• When adjusting the reticle to the point of aim, remember that 1 minute of angle equals approximately 2.54 cm (1 in) at 91.44 m (100 yd).
Therefore, if the impact point is 5.08 cm (2 in) low and 2.54 cm (1 in) right at 91.44 m (100 yd) Parallax Setting, you should adjust 2 minutes of angle up and 1 minute of angle left.
In the case of 45.72 m (50 yd) Parallax Setting, the adjusting value is 2×. In the case of 68.58 m (75 yd) Parallax Setting, the adjusting value is 1.5×.
5. Obtaining and changing the custom XR turret
(1) Obtaining the Custom XR Turret
Please see the voucher included in the display box for details to redeem your Custom XR Turret. Please note the riflescope can be used with the exist-
ing turret should you choose not to redeem the Custom XR Turret.
(2) Changing the Custom XR Turret
We recommend that you zero the riflescope with the existing turret as it is marked with graduations for each click value. Then follow the directions
below to install your Custom XR Turret.
1 Using the supplied hex key for Custom XR Turret (1.3mm) (1), loosen the three screws on the lateral face of the included turret by turning the
key counter-clockwise (Fig. 5-1).
• Be sure not to excessively loosen the screws. The screws may fall out.
• Loosen the screws uniformly.
2 Remove the turret.
Fig. 5-1