Instruction Manual

14
En
15
En
Maintenance
(1) Lens cleaning
To remove dirt or fingerprints, soak gauze or lens cleaning paper (silicon-free paper sold at camera retailers) with a small quantity of absolute alcohol (available from drugstores) and lightly wipe off the affected
areas.
Wiping with a handkerchief or leather may damage the lens surface and is not recommended.
Dust may scratch the lens surface or corrode the lens.
Brush dust off using a soft oil-free brush.
(2) Scope exterior
Use a soft dry cloth to wipe off any dirt or fingerprints that might accumulate.
It is not necessary to oil the scope's surface.
(3) Windage/elevation adjustments
These adjustments are permanently lubricated. Do not attempt to lubricate them. Cover them with the caps supplied, except when adjusting them, to keep out dust and dirt.
3 Attach the Custom XR Turret.
• The Custom XR Turret locks the turret in place so that you are unable to dial below the zero setting. Be sure to carefully align the
Zero mark on the Custom XR Turret with the vertical index line on the turret housing as mentioned in Step 4.
4 Align the zero mark on the turret with the vertical index line on the turret housing (Fig. 5-2).
5 Tighten the three screws by turning the hex key clockwise. Firmly tighten the screws so that the turret is secure.
• Tighten the screws uniformly.
Fig. 5-2