Operation Manual

73
TOP
The Tool Chest — Scanner Extras
Strip Film Offset
This is option is used to
position the fi lm in the
scan aperture. It is only
available with the SA-21,
FH-869S, and the optional
SA-30 and FH-869G.
To use this option, the thumbnail drawer must be open with
thumbnails displayed. Select the desired thumbnail and ad-
just its position using the Boundary Offset slider or by en-
tering a value in the text box to its right. If the right edge of
the thumbnail is cut off, move the slider to the right or enter
a larger value to bring it into position; if the left edge is cut
off, move the slider to the left or enter a smaller value. Note
that the direction of adjustment changes when thumbnails
are fl ipped or rotated.
To view the effects of changes to the boundary offset, click
the Reload Thumbnail button and check the results in the
thumbnail drawer. The changes will not be refl ected in the
preview area until the Preview button is clicked.
Strip Film Offset
Strip Film Offset
Numerical boundary offset ranges are shown below.
5000 ED, 4000 ED, COOLSCAN V ED, COOLSCAN IV ED
First frame Subsequent frames
0–144 -144 – 144
Medium-format fi lm (9000 ED, 8000 ED)
Frame size
6 × 4.5
6 × 6
6 × 7
6 × 8
6 × 9
Subsequent frames
-69 – 69
-93 – 93
-114 – 114
-127 – 127
-137 – 137
First frame
*
0–69
0–93
0–114
0–127
0–137
* Small negative values may be possible with the fi rst frame of medium-
format fi lm.
Manual Focus Adjustment
Use manual focus adjustment
when the desired results can
not be achieved using auto-
focus. Adjust focus using the
Position slider or by entering a value in the text box to its
right, then click the Preview button in the scan window to
refocus the scanner. The new focus position will be used un-
til the next time fi lm is inserted or Nikon Scan is restarted. To
focus the scanner automatically, click the autofocus button in
the scan window control area.