Operation Manual

95
TOP
Preferences— Single Scan
Single Scan
Single Scan
Scan Settings for Single Scans
Scan Settings for Single Scans
The “Single Scan” category is used to specify the tasks per-
formed au to mat i cal ly before and after single scans.
Before scan
Option Description
Auto ex po sure
for negative
fi lm
If this item is checked (the default set ting), an auto-
exposure operation will be per formed as necessary
before scanning fi lm negatives.
Auto ex po sure
for pos i tive
fi lm
If this item is checked (the default set ting), an auto-
exposure operation will be per formed as necessary
before scanning fi lm pos i tives.
Auto focus
If this item is checked (the default set ting), an auto-
focus operation will be per formed as necessary be-
fore making a scan.
“Before Scan”
“Before Scan”
If Perform auto focus when fi lm is inserted is selected in the
“Scanner Extras” palette, an autofocus operation will au to mat i cal ly be
per formed when a slide is inserted in a slide-mount adapter (5000 ED,
4000 ED, COOLSCAN V ED, COOLSCAN IV ED) or when a holder other
than the FH-869S or FH-869G is inserted in the 9000 ED or 8000 ED.
As a result, an autofocus operation will not au to mat i cal ly be performed
before the image is scanned, even if Auto focus is selected for “Before
scan.” In the case of the 9000 ED and 8000 ED, this applies only to the
fi rst frame in the holder; an autofocus operation will automatically be
performed prior to scanning for all subsequent frames.
After scan
Option Description
Close
window
and eject
fi lm
When this item is checked, the scan window automatical-
ly closes after scanning. Holders are automatically eject-
ed from the 9000 ED/8000 ED, and fi lm is automatically
eject ed from the SA-21, IA-20 (S), SA-30 (5000 ED/4000
ED), and SF-210/SF-200 (S) (5000 ED/4000 ED). The de-
fault setting is off.
Save to
disk
If this item is checked when Nikon Scan is used as a stand-
alone application, the im age created when the Scan but-
ton is clicked will be saved to disk instead of being opened
in an image window. When the Scan button is clicked, a
“Save” di a log will ap pear; spec i fy a name, lo ca tion, and
fi le type for the image. This op tion has no effect when
Nikon Scan is be ing used as a plug-in or TWAIN source for
another ap pli ca tion. The de fault setting is off.