Connection Guide for Coolpix

-7-
Disconnecting and Reconnecting the Pairing
Use any of the following methods to temporarily disconnect and reconnect the
pairing.
• Switch the setting in Network menu M Airplane mode in the camera.
You can set it to On to turn off all communication functions in places where
wireless communication is prohibited.
• Switch the setting in Network menu M Bluetooth M Connection in the
camera.
• Switch the setting in the y Connect tab M Auto link in SnapBridge.
You can reduce battery consumption of the smart device by disabling this setting.
Unpairing
• To pair with another SnapBridge-supported camera, use SnapBridge to remove the
registration of a paired camera in advance.
• If you have problems transferring images to a smart device, such as long transfer
times, you may be able to fix them by unpairing and then re-pairing.
1 In SnapBridge, tap z in
the y Connect tab, and
then tap End pairing M
Yes on the dialog that is
displayed.
• The camera and smart device
are unpaired.
2 For iOS, remove the registration of the device (registered as the
camera name).
• If you do not remove the registration of the device, you cannot re-pair.
Tips on Pairing
Connect
Connection options
End pairing
Allow Wi-Fi access
Select camera
Connect
Go
Close
Go to “Settings” > “Bluetooth”
in iOS and unpair (“Forget”) this
device. You will not be able to
pair with the device again until
you have unpaired the device.