Reference Manual

9
Using the WR-R11a/WR-R11b with the WR-T10: The Basics
3
Pair the devices.
•
Press the pairing buttons on the
WR-R11a/WR-R11b and WR-T10
simultaneously. Pairing is complete
when the red and green LEDs on
the WR-R11a/WR-R11b flash on and
off in sequence.
•
When pairing devices, place them close together.
A
Pairing Failure
If the red and green LEDs do not flash on and off in sequence, pairing has
failed. Release the pairing buttons on the WR-R11a/WR-R11b and WR-T10
and repeat Step 3.
A
Channel Selection
•
Devices that are not on the same channel cannot be paired.
•
Changing the channel on either device once pairing is complete will
interrupt the connection. The connection will resume when the devices
are again set to the same channel; the pairing process need not be
repeated.
A
Ending Pairing
Press the pairing button on the WR-R11a/WR-R11b; the green LED will
start to flash rapidly (about 5 times a second). Keep the button pressed for
about 3 seconds longer and the green LED will start to flicker (about 20
times a second). While the green LED is still flickering, press the pairing
button on the WR-R11a/WR-R11b twice in quick succession (within about
0.3 seconds). The green and red LEDs will flash twice simultaneously to
show that pairing has ended and all pairing data have been erased.
•
If pairing fails to end, the red LED will not light. In this case, end pairing
by repeating the procedure above.