User's Manual

19
❚❚ Image Transfer, Camera Control, and HTTP Server
If you choose any of the above options in Step 4 on page 9, follow
the steps below to connect to an existing network. Where you will
start depends on the option selected in Step 6 on page 10: if you
selected an option other than Direct (access point), start at
Step 1; otherwise, proceed to Step 2, below (Image transfer or
Camera control), or to Step 5 on page 21 (HTTP server).
1 Obtain or select an IP address.
Highlight one of the following options
and press J.
• Obtain automatically: Select this option if
the network is configured to supply the
IP address automatically.
• Enter manually: When prompted, enter an IP address and
subnet mask by pressing 4 and 2 to highlight segments
and 1 and 3 to change. Press J to proceed when entry is
complete.
2 Confirm the IP address.
The camera IP address will be displayed
as shown at right; press J. If Image
transfer or Camera control is selected,
proceed to Step 3; otherwise, proceed to
Step 6.