Reference Guide (PDF Edition)

D Cautions: Time-Lapse Videos
Sound is not recorded with time-lapse videos.
The shutt
er speed and the time needed to record the picture to the memory card may vary from
shot to shot. As a result, camera may be unable to take shots at the selected interval.
Shooting will not begin if a time-lapse video cannot be recorded at current settings, for example if:
the value selected for [Interval] is longer than that selected for [Shooting time],
[00:00'00"] is selected for [Interval] or [Shooting time], or
the memory card is full.
Time-lapse recording will not start if the recording time is shown in red in the [Time-lapse video]
display. Adjust the [Interval] or [Shooting time].
When 7680× 4320 is selected for [Frame size/frame rate], shooting will not start if a DX lens is
attached or [DX] selected for [Choose image area].
The K button cannot be used to view pictures while time-lapse recording is in progress.
For consistent coloration, choose a white balance setting other than 4[Auto] or D[Natural
light auto] when recording time-lapse videos.
Regardless of the option selected for Custom Setting c3 [Power off delay]> [Standby timer], the
standby timer will not expire while recording is in progress.
Shooting may end if camera controls are used, settings are changed, or an HDMI cable is
connected. A video will be created from the frames shot to the point where shooting ended.
The following end shooting without a beep sounding or a video being recorded:
Disconnecting the power source
Ejecting the memory card
D Adjusting Settings Between Shots
Shooting and menu settings can be adjusted between shots. Note, however, that the monitor will turn
off approximately 2s before the next shot is taken.
510
Time-Lapse Video
-
-
-
-
-