Reference Guide (PDF Edition)

Problems and solutions
517
Problems and solutions
Solutions to some common issues are listed below.
B
attery/display
The camera is on but does not respond:●
･ W
ait for recording and other operations to end.
･ If the problem persists, turn the camera o.
･ If the camera does not turn o, remove and reinsert the battery.
- Any data currently being recorded will be lost.
- Data that have already been recorded are not aected by removing
the battery.
The vie
wnder or monitor does not turn on:●
･ Have you changed the monitor mode? Choose a dierent monitor mode
using the
M
button.
･ Have you limited the choice of monitor modes available using the [Limit
monitor mode selection] item in the setup menu? Adjust settings as
required.
･ Dust, lint, or other foreign matter on the eye sensor may prevent it
functioning normally. Clean the eye sensor with a blower.
The vie
wnder is out of focus:●
･ Rotate the diopter adjustment control to adjust viewnder focus.
･ If adjusting viewnder focus does not correct the problem, set the focus
mode to AF-S and the AF-area mode to single-point AF. Next, select the
center focus point, choose a high-contrast subject, and focus using
autofocus. With the camera in focus, use the diopter adjustment control
to bring the subject into clear focus in the viewnder.
The display in the vie
wnder, monitor, or control panel turns o
without warning:
●
Choose longer delays for Custom Setting c3 [Power o delay].