INSTALLATION GUIDE 525 650 800 BRACKET KIT B L E N D I N G H I G H F I D E L I T Y A N D A R C H I T E C T U R E
Bracket Kit Contents 2 Brackets (525/650/800) 4 Wings for New Construction 9 #6 x 15/8” Phillips Head Drywall Screws (Includes 1 spare) 1 Hole Cutout Template Three Stage Installation System for Remodels or New Construction You install only the parts you need for a particular stage of construction. When the framing and wiring are finished, you install the bracket.
New Construction Installing the Wings and Bracket Attach the wings to the bracket by snapping them into the sides of the bracket. The wings can be shortened by breaking them along the scored lines if their length will interfere with a corner or eaves. You can mount the bracket horizontally or vertically (See Figure 2). Screw one side of the assembled bracket with wings to the stud using one of the supplied screws. Level the bracket. Screw the other side of the bracket assembly to the stud.
a hole about an inch above the center of your proposed speaker location (See Figure 3). If the wires movement is obstructed by a pipe or cable, fill the hole(s) with spackle or other patching compound and try another location. 2. When determining the final location of the cutout keep in mind that the frame and bracket will extend beyond the cutout. Make sure that you do not place the edge of the cutout directly next to a stud. Locate the studs using a stud sensor or hand-knocking.