I N S TA L L AT I O N G U I D E F O R U S E I N M U LT I - C H A N N E L M U S I C O R H O M E T H E AT E R S Y S T E M S HIGH DEFINITION, LEFT/CENTER/RIGHT CHANNEL BOOKSHELF LOUDSPEAKER HDLCRBX DS00420B-0_HDLCRbx.
CONGRATULATIONS! Thank you for choosing the HDLCRbx High-Definition, Left/Center/Right Channel Loudspeaker from Niles. With proper installation and operation, you should enjoy years of trouble-free use. Niles manufactures the industry’s most complete line of custom installation components and accessories for audio/video systems. To see the complete Niles product assortment, visit us on the Internet at: www.nilesaudio.
INTRODUCTION The Niles HDLCRbx High-Definition, Left/Center/Right Channel Loudspeaker is expressly designed for superior sonic quality in front left-, center-, or front right-channel applications. It employs advanced technology components that extract the subtle nuances in recorded music or the thunderous action sound in a movie. The HDLCRbx is the perfect choice wherever quality of sound is the most important consideration.
ACOUSTIC FINE TUNING The HDLCRbx includes acoustic fine-tuning controls on the rear panel. These controls enable optimization of the high frequencies and dialog with 3 dB of Treble Cut and 3 dB of Dialog Enhancement. D.S.F.G. DIRECTED SOUND FIELD GEOMETRY® DEFEAT The HDLCRbx includes a rear-panel control that enables the installer to deactivate the D.S.F.G. Directed Sound Field Geometry® in certain applications.
INSTALLATION CONSIDERATIONS RECOMMENDED AMPLIFIER POWER For satisfactory performance, we recommend using a surround amplifier with a power rating of 10 to 150 watts. Curiously, most loudspeakers are not damaged by large amplifiers, but rather by small amplifiers. If your system is playing loud music, a small amplifier will run out of power very quickly and can create damaging “clipping” distortions. A more powerful amplifier will play at the same volume without distorting.
LOUDSPEAKER PLACEMENT NOTE: THE NILES HDLCRBX LOUDSPEAKER IS DESIGNED FOR USE IN FRONT LEFT-, CENTER-, OR FRONT RIGHT-CHANNEL APPLICATIONS ONLY. FOR BEST RESULTS, PLACE THE HDLCRBX ON A STAND OR BOOKSHELF. FOR REAR-CHANNEL APPLICATIONS, WE RECOMMEND USING A NILES HDFX OR CM750FX LOUDSPEAKER.
As for placement height, place front left and right loudspeakers vertically on either side of the picture source, so that their tweeters are not more than 24 inches above or below the centerchannel loudspeaker’s tweeter (see Figure 2 on page 6). For best response, orient the loudspeakers so the tweeters face out. NOTE: DO NOT PLACE AN HDLCRBX LOUDSPEAKER TOO CLOSE TO A DIRECT-VIEW TV MONITOR, AS IT MAY CAUSE PICTURE DISCOLORATION. TEST THE PLACEMENT DISTANCE FOR PICTURE DEGRADATION BEFORE INSTALLATION.
PLACING AN HDLCRBX AS THE CENTER-CHANNEL LOUDSPEAKER (CONTINUED) HDLCRBX HDLCR HDLCR HDLCRBX Figure 2. If the HDLCRbx is placed above a TV, orient the loudspeaker with the tweeter up. If it is placed below a TV, orient the HDLCRbx with the tweeter down. • For installations where a perforated projection screen will be used, place the HDLCRbx, either horizontally or vertically, behind the screen at ear level, as shown in Figure 3 3. NOTE: WHEN PLACING THE HDLCRBX AT EAR LEVEL, SET THE D.S.F.G.
FINISHING THE INSTALLATION CONNECTING THE LOUDSPEAKER 1. At each loudspeaker, separate the loudspeaker wire so that at least 2 inches of each conductor are free. Strip away 1/4 inch of insulation from each loudspeaker wire. Using correct polarity, connect the appropriate conductor to each five-way binding post. NOTE: Observe correct polarity: Positive (+) goes to the RED post and negative (–) goes to the BLACK post. If you are unsure of wire polarity, see the section, Checking Loudspeaker Phase on page 8.
ACOUSTIC FINE TUNING Each HDLCRbx loudspeaker features separate Treble Cut and Dialog Enhance controls on the rear for acoustic fine-tuning after placement, as shown in Figure 4. Adjust these controls as follows: • Initially set Treble Cut to Flat and Dialog Enhance to Normal. • If a HDLCRbx is placed in a room with highly reflective surfaces like glass or tile or the reproduced sound is too bright, set the Treble Cut switch to – 3 dB to lower the highfrequency response.
Of course, there are some wires that appear completely identical. So be careful, or you might make a connection mistake. If you do, one loudspeaker will be playing “out-of-phase” with the other loudspeaker. A pair of out-of-phase loudspeakers works against each other, and the sound of the two playing together will be lacking in bass and sound “phasey.” If you suspect the sound is not right, and you cannot see any markings on the wire, try this simple test: 1. Stand halfway between the loudspeakers. 2.
OPERATION LISTENING AT HIGHER VOLUMES Achieving a reasonable volume of sound in a large room requires more amplifier power than it does in a small room. It is possible to turn the volume up so high that the amplifier runs out of power. This creates “clipping” distortion, which will make treble sound very harsh and unmusical.
SPECIFICATIONS Driver Complement • Two 5-1/4" TCC Woofers • 1" Teteron Tweeter with fluid cooling Design Principle • Acoustic suspension with a tuned port • D.S.F.G. Directed Sound Field Geometry® for optimum phase and frequency response Recommended Amplifier Power 10 to 150 watts per channel Nominal Impedance 4 ohm Frequency Response 45 Hz to 21 kHz, +/- 3 dB Sensitivity 90 dB with 2.83 V pink noise input, measured at 1 meter on axis Dimensions 21" L x 7-1/4" W x 9-3/4" D (53.3 cm L x 18.4 cm W x 24.
NOTES 12 DS00420B-0_HDLCRbx.
NOTES NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373 DS00420B-0_HDLCRbx.
BLENDING HIGH FIDELITY AND ARCHITECTURE® Niles Audio Corporation 1 2 3 3 1 S . W. 1 3 0 S t r e e t M i a m i , F l o r i d a 3 3 1 8 6 Designed and Engineered in USA Made in China ©2008 Niles Audio Corporation. All rights reser ved. Niles, the Nil e s l o g o s , B l e n d i n g H i g h F i d e l i t y a n d Architecture and D.S.F.G. Directed Sound Field Geometr y are registere d t r a d e m a r k s o f N i l e s A u d i o C o r p o r a t i o n . TCC is a trademark of Niles Audio Corporation.