The KIRBY s compatible with all Nile infrared extenders systems, IntelliControl® and Multi Zone recovers and amplifier. i3 « Two infrared LED give the KIRBY exceptional change and power. With proper placement, a single [RB1 flasher can confrere an entire stack of audiovisual compendious, 22N (i * The BIRTH is equipped with 2 3.5mm plug. This provides you with easy hookup. + An adhesive-backed steep is included with the IRB, providing quick, secure, mousing.
Acetylene ek ok The KIRBY is typically used s a “flooding” dasher 1o control 3 stack of audiovisual compare For this type of application, place the KB with its LED pointed straight up and at East an inch i front of the equipment yau wish o control (See Figure 2. The effective range varies between & to 30 depending on the brand and for the medal of the audiovisual compo. bent.
a r90m. In this type of situation the (RB1 has an effective operational range of 18' to 307 depending on brand and model of audiovisual equipment). RSN Route the connecting wire o the main system unit. Most Nile IR main system units feature specific flasher outputs that are delectable between fow and high output, Insert the 3.5mm plug of the Tintoretto ane of these delectable “FLASHER OUTPUTS” jacks on the MSU.
eighteen gauge to-conductor wire. For distances hundred feet use a sixteen Gauge two-conductor wire BE SURE TO OBSERVE PROPER POLARITY WHEN EXTENDING THE FLASHER WIRE. The wire lead marked with a gray snipe is positive 43 the unmarked lead is negative ). Mounting the KIRBY Test the aeration of the [RET in the planed taunting location. I all of the components operate correctly via the 1R repeater system. mount the KIRBY using if's self adhesive strip Make sure the mounting surface is clean and dry.
the larger the wire, 2. twee physically ones sy Apical 1% Feedback Loop if there is an 1R sensor and an iR flasher located within the same “optical [R feedback atop” can our, This scours when the IR culprit from a flasher unintentionally reaches an IR sensor Inca ted within the same room, The R commands are eventually forwarded back to the IR flasher ard the whole process endlessly repeats itself. This effect is similar to acoustical feedback he howling or whistling sound heard in a P.A.