INTRODUCTION The MS210 IR Microsensor® is designed for use with the Sites infrared extender systems. Installed in 4 remits room location, the MS210 receives the I commands transmitted from your existing hand-held remotes in that room. The. ‘commands are carried via a CAT 5 cable to your AN equipment in another room, and instantly “repeated. The M5210 is compatible with all current Nile infrared terrorist.
+ CH.
Raa |} ain ECB Byte : unit " i REL fit 1 [ lea 5 Figure 2. more un the Sensor cable drum enn sensor the MSU 1 Greene 17 20 Green BATS 5 Orienteering GROUND b= Heine EMPTY 5 Here STATUS 8x Rage EET 7 Beeton ine EMPTY trim O'Casey Tu EIT Drown = 1 Figure &. weeing Flanagan 5 The MS210 is designed ta surface-mount almost anywhere.
Avoiding Electrical interference Aud locating the M5210 near any potential sources of Electra-Magnetic Interference {EMI The most common Souffles are: 1. Light dimmers or variable speed controls for ceiling fans. These controls emit more interference when tuned down halfway. They emit lite or ne interference when fumed up all the way (brightest or highest position}. 2 Large appliances {air-conditioners, pumps, motors, Compressor S; Ate) 3.
INSTALLATION You may splice the MS210 cable to another cable by soldering or crimping the connections. Make sure that yous maintain proper polarity and correct connections through the splice. Connecting to the main system unit 1. Strip 3/4" of insulation from the end of each wire. Tightly twist the eid of each wire until no frayed ends remain. 2. Usa a small fathead screwdriver or your thumbnail To raise the locking tabs, exposing ihe holes ont ihe mandible connector plug of the MSU. 3.
3 Test for interference from the following sources: « Nan or halogen lights in the room « Light dimmers, beginning with those closest lo the MS210 Observe the MS210's LED while performing ait the tests. It is impassible to have interference from more than one source, Eliminating optical feedback In same installations, twa conditions combing to create an optical feedback loop.
pain ind 1R System Compatible with virtually all brands of remotes using carrier frequencies of kHz, KHZ, and kHz 1R Receiving Range Varies depending on remote strength; Typically 21035 1R Receiving Angle 80° off-axis {horizontal and vertical) at 20° Mounting Surface-mount. Self-adhesive mounting strip included Unit Dimensions Overall Unit.
LIMITED WARRANTY HOLES AIDED CORPORATION (LINES) WARRANTS TTS PASSIVE PRODUCTS. (THOSE HOT REQUIRING AC OF BATTERY POWER) 70 THE ORIGINAL PURCHASER TD BF FEE OF MANUFACTURING DEFECTS (K MATERIAL AD WORKMANSHIP FOR A PERIOD OF TWO YEARS FROM DATE OF PURCHASE. THIS WARRANTY 15 SUBJECT 15 THE FOLLOWING AUDITOR ADDITIONS SHO IMITATIONS.