Installation Instructions

ManualsBrandsNilfisk A ManualsElectronicsIoT module

Nilfisk A/S

Industrivej 1 Switchboard Confidential 19.01.2021/

DK-9560 Hadsund +45 72 18 21 00 , Page 1 of 5

Denmark

Manual

Nilfisk Telemetry module TC-1

Functional description

The TrackClean module TC-1 is an IoT module which collects data from machines via CAN, UART and/or

analog inputs and send it to cloud. There is also 2 digital outputs with special functions.

Furthermore it have location positioning (GNSS), motion sensor, temperature sensor and built-in backup bat-

tery.

Precautions!

• Follow installation instructions for the relevant target machine

• To be installed only by Nilfisk authorized people

• Do not open the housing

• Do not change or modify the cable

• The module must be installed with at least 12.1 cm distance from any part of machine operators hu-

man body.

Summary of content (5 pages)

PAGE 1
Manual Nilfisk Telemetry module TC-1 Functional description The TrackClean module TC-1 is an IoT module which collects data from machines via CAN, UART and/or analog inputs and send it to cloud. There is also 2 digital outputs with special functions. Furthermore it have location positioning (GNSS), motion sensor, temperature sensor and built-in backup battery.
PAGE 2
Specifications Product specifications Supply voltage 8-58VDC / 0.8A or 5V / 1A Wireless interface GSM, LTE Cat-M1, NB-IoT, GNSS, Bluetooth 5.0 Key_Switch input active 5 – 60V Analog inputs (7 inputs) 0 – 60V Digital output Open drain, max 60V / 200 mA Backup battery 3.
PAGE 3
LED Status LED mode LED pattern Status indication Network (Red) No light Off or in stand-by mode Long flashing Searching network Short flashing Connected GNSS (Gren) Off Searching (if Red LED is flashing) On (constant) Location fix Bluetooth Off BT deactivated or module is off Flashing BT on, not connected On (constant) BT on, connected Nilfisk A/S Industrivej 1 DK-9560 Hadsund Denmark Switchboard +45 72 18 21 00 Confidential 19.01.
PAGE 4
Connections Use counterpart: ITT CTC 132015-0075 ITT CTC connector pin # Signal name Description Wire color 1 GND GND (0V) Dark Green 2 UART_TX TX signal for NEO1 UART (cross to RX) Red 3 UART_RX RX signal for NEO1 UART (cross to TX) Black 4 GND GND (0V) Light Green 5 NC Not connected 6 Analog In1 Analog input for sensor / measurement Orange 7 Analog In3 Analog input for sensor / measurement Yellow 8 Analog In5 Analog input for sensor / measurement Yellow / Black 9 Analo
PAGE 5
Regulatory approvals and information CE This product comply with: RED 2014/53/EU directive with respect to radio, EMC and safety requirements. RoHS 2011/65/EU directive with respect to restrictions of hazardous substances. This product contains radio equipment operating in the frequency bands and with max TX power as indicated below: Radio Technology Cellular 2G Harmonized Radio Standard EN 301 511 V12.5.1 Frequency range [MHz] Cellular 3G Cellular 4G EN 301 908-13 V11.1.2 BT LE / WiFi 2.