ATTIX 30 H / M / PC / XC ATTIX 50 H / M / PC / XC Operating Instructions 107400338 A en
ATTIX 30/50 H/M Contents 1 english Important safety instructions .............................................................................................2 2 Description 2.1 2.2 Operating elements...............................................................7 Operating panel.....................................................................8 3 Before starting the cleaner 3.1 3.1.1 3.1.2 3.2 3.3 3.4 Assembling the vacuum cleaner...........................................
ATTIX 30/50 H/M english 1 Important safety instructions Symbols used to mark instructions Prior to using the appliance for the first time, be sure to read this document through and keep it ready to hand. DANGER Danger that leads directly to serious or irreversible injuries, or even death. WARNING Danger that can lead to serious injuries or even death. CAUTION Danger that can lead to minor injuries and damage.
ATTIX 30/50 H/M english Dust Class M (medium). The dusts which belong to this class are: dusts with OEL values1) > 0.1 mg/m³ as well as saw dust. The machine is tested in its entirety by vacuums for this dust class. The maximum degree of permeability is 0.1% and the disposal must be low dust. The air flow in Safety Vacuum systems has to be strictly controlled to achieve a minimum flow rate of Vmin = 20 m/s in the suction hose.
ATTIX 30/50 H/M Clean the water level limiting device regularly and check for signs of damage. english Only carry out maintenance work described in the operating instructions. Always pull the out the mains plug before cleaning and maintenance of the vacuum cleaner. During maintenance and cleaning, handle the vacuum cleaner in such a manner that there is no danger for maintenance staff or other persons. In the maintenance area 1. Use filtered compulsory ventilation 2. Wear protective clothing 3.
ATTIX 30/50 H/M Risks english Electrical components DANGER Electric shock due to faulty mains connecting lead. Touching a faulty mains connecting lead can result in serious or even fatal injuries. 1. Do not damage the mains power lead (e.g. by driving over it, pulling or crushing it). 2. Regularly check whether the power cord is damaged or shows signs of ageing. 3.
ATTIX 30/50 H/M english Hazardous materials WARNING Hazardous materials. Vacuuming up hazardous materials can lead to serious or even fatal injuries 1. The following materials must not be picked up by the vacuum cleaner: -- hot materials (burning cigarettes, hot ash, etc.) -- flammable, explosive, aggressive liquids (e.g. petrol, solvents, acids, alkalis, etc.) -- flammable, explosive dust (e.g. magnesium or aluminium dust, etc.
ATTIX 30/50 H/M 2 Description 2.
ATTIX 30/50 H/M english 2.
ATTIX 30/50 H/M 3 Before starting the cleaner 3.1 Assembling the vacuum cleaner 3.1.1 Taking accessories out of the packaging *) ø 27 ø32 A ø36 ø38 A 3.1.2 Attaching the suction pipe holder to the suction pipe *) 3.2 Before starting the cleaner 1. Take vacuum cleaner and accessories out of the packaging. 2. The mains plug should not yet be inserted into a socket. 3. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. 4.
ATTIX 30/50 H/M english Type of dust Filter bag/waste bag/filter element • Dusts with OEL values >0.1 mg/m3 (observe any additional national regulations) • Wood dusts & concrete dusts Waste bag (5 pcs.) Order No. ATTIX 30-XM: 302000804 ATTIX 50-XM: 302000728 • Dusts with OEL values >0.1 mg/m3 (observe any additional national regulations) • Wood dusts & concrete dusts Filter bag Order No. ATTIX 30-XM: 302004000 ATTIX 50-XM: 302004004 • Dusts with OEL values >0.
ATTIX 30/50 H/M ø 27 ø36 A Inserting the filter bag "M" ø32 ø36 ø38 A ø 27 3.4 ø32 ø38 A A 7. Attach the upper section of the vacuum cleaner. 8. Close the retaining clamps (A). Ensure that the retaining clamps fit properly. 1. The mains plug should not yet be inserted into a socket. 2. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. 3. Insert the filter bag into the dirt tank. 4. Press the filter bag connection firmly on to the inlet fitting.
ATTIX 30/50 H/M english 12 ø 27 ø32 ø36 ø38 A A 5. Attach the upper section of the vacuum cleaner. 6. Close the retaining clamps (A ). Ensure that the retaining clamps fit properly.
ATTIX 30/50 H/M 4 Control / Operation 4.1 Connections 4.1.1 Connecting the suction hose english 1. Connect the suction hose. 4.1.2 Electrical connection 1. Ensure that the cleaner is switched off. 2. Insert the power cord into a properly installed and fused socket with earthing contact. The operating voltage shown on the rating plate must correspond to the voltage of the mains power supply. 4.2 Switching on the vacuum cleaner 4.2.
ATTIX 30/50 H/M english 4.2.3 Suction power control *) Switch position Function The suction power control switch allows precise adaptation of the suction power for different cleaning tasks. auto 4.2.4 Auto-On/Off-Operation "auto" switch position *) 1. Switch off the vacuum cleaner. 2. Switch off the power tool. The vacuum cleaner is switched on and off by the power tool connected. Dirt is picked up from the source of dust immediately.
ATTIX 30/50 H/M 4.3 Cleaning the filter element 4.3.1 Cleaning the filter element " Push&Clean System " (ATTIX 30- / 50-xx PC) english Filter Cleaning System Only for vacuum cleaning without a filter bag and without a cloth insert filter. If suction performance drops: 1. Turn switch to position "I" (maximum suction power). 2. Close the nozzles or suction hose opening with the palm of your hand. 3. Press the button to start filter cleaning three times.
ATTIX 30/50 H/M english 5 Applications and techniques 5.1 Techniques If used correctly, additional accessories, suction nozzles and suction hoses can enhance the cleaning action and reduce the cleaning effort. Effective cleaning is achieved if you follow just a few guidelines in combination with your own practical experience in special fields. Here are some basic tips. 5.1.1 Picking up dry substances CAUTION! Do not pick up flammable substances.
ATTIX 30/50 H/M 6 After finishing work 6.1 english Switching the vacuum cleaner off and storage A B C E 1. After picking up hazardous dust, vacuum clean the outside of the cleaner. 2. Switch off the cleaner and pull the mains plug out of the socket. 3. Remove the suction hose form the vacuum cleaner and close the inlet fitting (A) with the plug (B). 4. Wind up the power cord onto the handle (C).
ATTIX 30/50 H/M 7 Maintenance 7.1 Maintenance plan After finishing work When required 7.2.1 Emptying dirt tank 7.2.2 Replacing the safety filter bag "H" = 7.2.3 Replacing the filter bag "M" = 7.2.4 Replacing the disposal bag "M" = 7.2.5 Replacing filter element "H" (Push&Clean) = 7.2.6 Replacing filter element "H" (XtremeClean) = 7.2.7 Replacing filter element "M" (Push&Clean) = 7.2.8 Replacing filter element "M" (XtremeClean) = = 7.2 Maintenance work 7.2.
ATTIX 30/50 H/M 7.2.2 Replacing the safety filter bag "H" 1. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. ø 27 ø32 ø36 ø38 A A During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. CAUTION! In the case of asbestos abatement wear additional singleuse clothing. Removing the safety disposal bag 1. Close the disposal bag with the string (B). 2. Carefully remove the filter bag connection from the inlet fitting. 3.
ATTIX 30/50 H/M 7.2.3 Replacing the filter bag "M" ø36 ø 27 ø32 ø38 A A 1. Switch off the vacuum cleaner and pull the mains plug out of the socket. 3. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. Never use the vacuum cleaner without a filter. Removing the filter bag: 4. Carefully remove the filter bag connection from the inlet fitting (B). 5.
ATTIX 30/50 H/M 7.2.4 Replacing the disposal bag "M" A A ø36 ø38 ø 27 ø32 1. Switch off the vacuum cleaner and pull the mains plug out of the socket. 2. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. Never use the vacuum cleaner without a filter. Removing the disposal bag: 3. Close the disposal bag with string (B). 4.
ATTIX 30/50 H/M 7.2.5 Replacing filter element "H" (Push & Clean System) During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. CAUTION! In the case of asbestos abatement wear additional singleuse clothing. ø 27 ø32 ø36 ø38 A A C D Never use the vacuum cleaner without a filter. B 1. Switch off the vacuum cleaner and pull the mains plug out of the socket. 2. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner.
ATTIX 30/50 H/M 7.2.6 Replacing filter element "H" (Xtreme Clean System) ø 27 ø32 A ø36 ø38 A 1. Switch off the vacuum cleaner and pull the mains plug out of the socket. 2. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. CAUTION! In the case of asbestos abatement wear additional singleuse clothing. Never use the vacuum cleaner without a filter.
ATTIX 30/50 H/M english A ø36 ø38 ø 27 ø32 A 7.2.7 Replacing filter element "M" (Push & Clean System) A ø36 ø38 ø 27 ø32 A During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. 11.Attach the upper section of the vacuum cleaner. 12.Close the retaining clamps (A). Ensure that the retaining clamps fit properly. 1. Switch off the vacuum cleaner and pull the mains plug out of the socket. 2.
ATTIX 30/50 H/M 7.2.8 Replacing filter element "M" (XtremeClean System) english A A ø36 ø38 ø 27 ø32 1. Switch off the vacuum cleaner and pull the mains plug out of the socket. 2. Open the retaining clamps (A) and remove the upper section of the vacuum cleaner. During the following work, ensure that dust is not unnecessarily spread around, Wear a P2 breathing mask. Removing the filter elements: 3. Open filter tension part (B). 4. Remove carefully the cassettes with filter elements.
ATTIX 30/50 H/M english 8 Troubleshooting Fault ‡ Motor does not start ‡ Motor does not run in automatic mode *) ‡ The acoustic warning sounds. (Reduced suction power) ‡ No suction power during Cause Remedy > Fuse of the mains socket has blown. • Connect mains fuse. > Overload protection switch has tripped. • Switch off the vacuum cleaner and allow it to cool for approx. 5 minutes. If the cleaner cannot be started again, contact the Nilfisk-Alto service department. > Motor is faulty.
ATTIX 30/50 H/M 9 Further information 9.1 Recycling the cleaner english Make the old cleaner unusable immediately. 1. Unplug the cleaner. 2. Cut the power cord. 3. Do not discard of electrical appliances with household waste. As specified in European Directive 2002/96/EC on old electrical and electronic appliances, used electrical goods must be collected separately and recycled ecologically. Contact your local authorities or your nearest dealer for further information. 9.
ATTIX 30/50 H/M english 9.
www.nilfisk-alto.com HEADQUARTER DENMARK Nilfisk-Advance Group Sognevej 25 2605 Brøndby Denmark Tel.: (+45) 43 23 81 00 Fax: (+45) 43 43 77 00 E-mail: mail@nilfisk-advance.dk SALES COMPANIES AUSTRALIA Nilfisk-ALTO 48 Egerton St. PO box 6046 Silverwater NSW 2128 Australia Tel.: (+61) 2 8748 5966 Fax: (+61) 2 8748 5960 AUSTRIA Nilfisk-Advance GmbH Nilfisk-ALTO Metzgerstrasse 68 A-5101 Bergheim bei Salzburg Tel.: (+43) 662 456 400-0 Fax: (+43) 662 456 400-34 E-mail: info@nilfisk-alto.at www.nilfisk-alto.
