08.01.2007 Nilfisk-ALTO C 120.
Printed in China Copyright © 2007 Nilfisk-ALTO
Index 1 2 3 4 5 6 7 8 9 10 Safety precautions and warnings .............................................3 Description ...............................................................................4 Before you start using your pressure washer ...........................5 Operating your pressure washe ...............................................6 Fields of Application and Working Methods...............................................................8 After using your pressure washe ......................
Extension cables should be of a watertight construction and comply with the below-mentioned requirements for length and cable dimensions. 1.0 mm² 1.5 mm² 2.5 mm² max. max. max. 12.5 m 20 m 30 m z Cable connections should be kept dry and off the ground. Mains power connection The following should be observed when connecting the high pressure washer to the electric installation: z Only connect the machine to an installation with earth connection.
3 Before you start using your pressure washer 3.1 Mounting of trolley handle (models with trolley handle) 1. Remove the label on top of machine. 2. Push down the trolley handle (12) into the machine. Secure the handle by tightening the 2 screws. 3. Mount the hose hook (14) on the handle (3 screws). Note: the hose hook can be mounted on the front as well as on the back. Front position is to be used if the product is used together with a special wall hook for wall storage. 3.
3.4 Mounting of high pressure hose Attach the high pressure hose (4) to the spray gun (7). Detach the high pressure hose by pressing the pawl (A). 4 Operating your pressure washer 4.1 Connection of high pressure hose 4.2 Mounting of spray lance and Click & Clean nozzles 1. Mount the high pressure hose on the outlet (3). 1. Push the spray lance (6) into the spray gun (7) and screw it on. Note: The spray lance (6) has a built-in low pressure nozzle that can be used for flushing away dirt. 2.
4.3 Water connection An ordinary 1/2" garden hose of min. 5 m and max. 25 m will be suitable. NOTE: Connection to the public mains according to regulations. 4.4 Start and stop of the machine (when connected to a water supply) The machine must not be operated while hanging on the wall hook! The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. IMPORTANT: Point the nozzle at the ground. 1. Check that the machine is in upright position.
4.5 Start the machine (when connected to open containers (suction mode)) The washer can take in water from a rain water tank as an example. The hose for the water supply must not be too long, approx. 5 m. Make sure that the water tank is not placed on a lower level than the machine. 4.6 Pressure regulation on the TORNADO® PRnozzle 1. Place the other end of the water hose in the water tank. Use an external filter if the water contains impurities. 2. Press the start/stop switch "I". 3.
5.2 Typical fields of application Below you will find a description of a lot of cleaning tasks which can be solved by a pressure washer from Nilfisk-ALTO in association with accessories and detergents. Task Accessories ‘Click Cleaning method & Clean’ Car Car nozzle, auto brush, underchassis nozzle, Foam sprayer, Car Combi Cleaner 1. Apply Car Combi Cleaner with the foam sprayer. Always start from the bottom and work upwards. Let Car Combi Cleaner act for at least 5 min. 2.
6 After using your pressure washer 6.1 Storing the washer , 6.2 Winding up of electric cable and high pressure hose The machine should be stored in a frost-free room! Pump, hose and accessories should always be emptied of water prior to storing as follows: 1. Stop the machine (press the start/stop switch “O” (1) and detach water hose and accessory. 2. Restart the machine and activate the trigger. Let the machine run until no more water runs through the spray gun. 3.
6.3 Storage of accessories B A D C E 6.4 Wall storage The standard accessories (spray gun and spray lance (a), nozzles (b) foam sprayer (c)) can be stored on the pressure washer. The nozzle cleaning tool (d) and a Click & Clean brush (e) can also be stored on the product. The pressure washer can be stored on a wall on a special wall hook (not standard). A Only mount the wall hook on a sturdy wall. Adjust the length of the screws and size of rawlplugs to the type of wall.
z Make sure that no sand or dirt is blocking the movement of the pawl on the Click & Clean spray lance. Rinse according to requirement. z Rinse the detergent spraying attachment after use. z Clean the nozzles. Any repair should always be made in an authorized workshop with original spare parts. 7.1 Cleaning of water inlet filter Clean the water inlet filter regularly once a month or more frequently according to use. Carefully loosen the filter with a screwdriver and clean it.
8 Trouble-shooting To avoid unnecessary disappointments, you should check the following before contacting the NilfiskALTO service organization: Symptom Cause Recommended action Machine refuses to start Machine not plugged in Defective socket Fuse has blown Defective extension cable Plug in machine. Try another socket. Replace fuse. Switch off other machines. Try without the extension cable. Fluctuating pressure Check that hoses and connections are airtight.
9 Further information 9.1 Recycling the washer Make the old cleaner unusable immediately. 1. Unplug the cleaner and cut the electric cable. Do not discard electrical appliances with household waste. 9.2 Warranty conditions 14 Nilfisk-ALTO guarantees high pressure washers for domestic use for 2 years. If your high pressure washer or accessories are handed in for repair, a copy of the receipt must be enclosed.
9.3 Accessories Only use original accessories. Click & Clean Car nozzle Special nozzle for enameled surfaces. Optimal distance: 30 - 50 cm. Click & Clean Undershassis nozzle 90° angled special nozzle for undercarriage and wheel arches. Integrated guide shoes. Click & Clean Multiangle adaptor Adjusted in angles from 0° - 90° for better working posture and cleaning of hard to get at places as for instance barrels or the underside of the lawn mower. Fits all nozzles.
Detergents Stone & Wood Cleaner For flagstones, brick- and woodwork. Suitable for moss and algae. Plastic Cleaner For plastic and synthetic materials such as garden furniture. Metal Cleaner For cleaning of metal such as garden tools. Car Combi Cleaner For cars etc. With rinsing wax. Alu Cleaner For surfaces of aluminium. Applied with an atomizer. Oil & Grease Cleaner For cleaning of grease and oil on motors for instance. Applied with an atomizer.
http://www.nilfisk-alto.com HEAD QUARTER DENMARK Nilfisk-Advance Group Sognevej 25 DK-2605 Brøndby Tel.: +45 4323 8100 Fax: +45 4343 7700 E-mail: mail@nilfisk-advance.dk SALES COMPANIES FRANCE PORTUGAL Nilfisk-ALTO ALTO France SAS Aéroparc 1 19 rue Icare 67960 Entzheim Tel.: +33 3 88 28 84 00 Fax: +33 3 88 30 05 00 E-mail: info@nilfisk-alto.fr www.nilfisk-alto.com Nilfisk-ALTO Division of Nilfisk-Advance Lda. Sintra Business Park Zona Industrial Da Abrunheira Edificio 1, 1° A P2710-089 Sintra Tel.