Operation Manual

18
MULTICLEANER 7-53
Original Instructions
7.4 Cleaning of robot
7.4.1 General
After use, the robot must be cleaned. This can be done with a high
pressure washer. Never point the high pressure jet directly at the
internal parts of the MULTICLEANER. Always make sure that the
ultrasonic sensors on the side of the MULTICLEANER are clean.
Important: The high pressure water jet must never point directly at
electricity boxes, wires or ultrasonic sensors. It is also important that
the two electricity boxes are always kept closed.
7.5 Storage
7.5.1 Frost protection
The best frost protection will be to store the MULTICLEANER in a
frost free area. If not possible, the following precautions must be
taken to protect the motor/pump unit against frost.
Lead the water inlet hose into a 5 l container with an anti-freeze.
Under manual control select HPW and press arrow up to activate
the pump.
After approximately 5 sec. the anti-freeze has reached the nozzle of
the horizontal arm.
Now press arrow up to deactivate the pump again.
The anti-freeze can be collected and re-used.
7.6 Transport
7.6.1 Trailer
When transporting the MULTICLEANER on a trailer or in a car, it
must be placed so that its weight is evenly distributed on the trans-
porting axles. Its dead weight is 285 kg. If the outdoor temperature
is below +2 degrees, the MULTICLEANER must be frost protected
as described in section 7.5.1.
Note: The gear of the machine must not be engaged during trans-
port.
7.6.2 Application of ramps/
winches
If applying chutes these must be correctly mounted on the truck
bed so that the contact surface is close to the edge of the truck
bed. Thus the biggest contact surface will be supported by the truck
bed. The chutes must be approved for carrying the weight of the
MULTICLEANER at a minimum (285 kg).
The trailer or the vehicle must have a winch so that the MULTI-
CLEANER can be safely loaded/unloaded without getting out of
control.
7.6.3 Fastening during
transport
Use band lashings/polyester bands for fixing of the MULTICLEAN-
ER during transport. Place a chock under the wheels.
Note! The MULTICLEANER must be secured during transport.