Operation Manual

6
SOLAR BOOSTER D/EH
Original Instructions
3 Installation
3.1 Temperature conditions
The machine should be in-
stalled in a frost-free room.
This applies to pump as well as
pipelines incl. of outlet points.
If connected to outdoor outlet
points it should be possible to
close and emp ty that part of the
line which is exposed to frost.
The maximum ambient tempe-
rature for the machine is 40°C.
2 Description
2.1 Application
This high pressure hot water
washer has been developed
for stationary installation and
professional use within:
- agriculture
- light industry
- transport
- building and construction
- service
Section 4 describes how to use
2.2 Operation elements
See illustration at the end of the manual
1 High pressure outlet (quick coupling, male)
2 Main switch
3 Start push button (illuminated, green)
4 Stop push button (illuminated, red)
5 Heating ON/OFF push button (illuminated, yellow)
6 Pressure gauge
7 Water inlet (quick coupling, female)
8 Thermostat (temperature adjustment)
9 Electric cable
10 Inspection window (hour counters, error messages)
11 Overheat fuse - resetable
12 Chimney
the high pressure hot water
washer.
Only use the high pressure
hot water washer for purposes
described in this manual.
The safety precautions must be
observed to prevent damage
to the machine, the surface to
be cleaned or severe personal
injuries.
Max 40 °C
Min 2 °C
and in the event of excessive
motor temperature (obstructed
ventilation etc.), the entire
machine will automatically be
disconnected from the mains
supply.
Short circuit protection
The machine is equipped with
a short-circuit protection. In the
event of short-circuits in the
machine, the protective device
will disconnect the entire ma-
chine from the mains supply.