Operation Manual

8
Extreme
DE
FR
ES
PT
I
T
NL
SV
NO
DA
FI
EN
Changing the active carbon fi lter
The active carbon fi lter removes bad
smell from the exhaust air. Change the
active carbon fi lter 1-2 times a year.
The active carbon fi lter is located
behind the dust bag and prefi lter.
Always use original dust bags and
fi lters.
1. Release the hose connection from
the suction inlet by turning the
hose connection counter-clockwise
and then remove it.
2. Open the lid by pushing the button.
3. Seal the dust bag by pulling the
cardboard fl ap.
4. Remove the dust bag.
5. Take out the fi lter holder.
6. Remove the old active carbon fi lter.
7. Fit the new active carbon fi lter.
8. Insert the fi lter holder on the pin
and push in place.
9. Insert the dust bag. If the dust bag
is closed push the cardboard fl ap
down to open it. Check that the
dust bag is correctly fi tted.
10. Close the lid.
11. Insert the hose connection into the
suction inlet and twist it clockwise
to lock it.
Changing the HEPA fi lter
The HEPA fi lter cleans the exhaust
air from micro particles the dust bag
can not keep. The HEPA fi lter can
not be brushed or washed clean. The
X150, X200, X210, X250 and X300
models have an HEPA fi lter indicator
that shows when to change the HEPA
fi lter. Always use original dust bags
and fi lters.
1. Open the lid on the machine under-
side with a coin or a screw driver.
2. Take out the HEPA fi lter.
3. Insert the new HEPA fi lter. Check
that the HEPA fi lter is correctly
fi tted.
4. Put the lid back and close it with a
coin or a screw driver.
4
Adjust the suction power
Models with a sliding valve on the
hose handle - Eco, X100, X110,
X150, X200 and X210
The suction power is maximal with
the sliding
valve closed
and minimal
when all open.
Adjust the
suction power
by putting the
sliding valve
in the desired
position.
Models with three step adjustment
- X150, X200 and X210
The suction power
is adjusted with
the sliding valve
and also with the
touch control on
the machine.
Models with fi ve step adjustment
remote control - X250, X300
The suction power
is adjusted on the
remote control on
the hose handle.
Hose handle with
remote control
battery replacement,
battery type CR2032
1. Carefully remove the remote control
unit with a small, fl at tool.
2. Remove the old
battery - replace
with new type
CR2032.
3. Carefully reas-
semble the con-
trol unit back to
the hose handle
by pushing it in
place at handle.
5
5b
Eco, X100, X110,
X150, X200, X210
X250, X300
X150, X200, X210