Operation Manual

40
4.1 Replacing the dust bag
The central vacuum cleaner is fi tted with a dust bag as standard;
never vacuum without a dust bag installed.
Grasp the edge of the lid and pull upwards to open it, Fig. 11.
Replacing the dust bag: Remove the old dust bag by turning
the cardboard stiffener to the right or left so that the raised part
of the inlet is in line with the opening in the card. Now slide the
bag off the bag nozzle.
Fit the new dust bag as follows: Push the opening in the card-
board over the elevation on the inlet and pull on the new bag.
Turn the cardboard to lock the bag in place. NB! Turn the edges
of the dust bag down into the container. This is to avoid dama-
ging the bag with the lid.
The cardboard stiffener locks the bag in place when you twist it
as shown in Fig. 12 above.
The opening in the card must line up and slide over the elevation
on the inlet before you twist the cardboard stiffener to lock it.
4.2 Replacing / cleaning the fi lter
Open the lid and take out the dust bag as described earlier.
The fi lter sits at the bottom of the container around the motor
housing. Never use the central vacuum cleaner without a
fi lter installed.
Pull the fi lter out of the container, Fig. 13. The fi lter can be clea-
ned by shaking it or washing it in water.
If you wash the fi lter, you must let it dry completely before
refi tting it.
Take the cleaned/new fi lter and place it in the bottom of the con-
tainer. Press the outer edge of the fi lter down against the sides
of the container so that the fi lter bulges up slightly. Then push
the fi lter down into place. Make sure the fi lter is packed in tightly
against the motor housing, Fig. 14. Reinstall the dust bag and
replace the lid. Check that the lid is fi rmly secured.
4 Filter and dust bags - Supreme 100
Filter
Filter
Motor housing
Fig. 14
Fig. 12
Fig. 13
Fig. 11