User's Manual

Instruction Manual
Please read the Instructions carefully before using the product.
Product:
Remote Control Transmitter for Switches.
Model no.:
BH-O,BH-P
Installation:
Install one (1) x 12V (23A) battery in the compartment, make sure the installation of battery is correct.
Features:
◆
The Outlets can be manually operated or via the handy Remote Control.
◆ Individual ON & OFF function for the remote control.
◆ Easy to use and operate. Use one transmitter to match more socket receivers or program more than
one transmitter to each socket. Any one transmitter and socket receiver can match use after finish
programming operation. So the socket receiver and remote control can sell separately.
◆The socket receiver will still rema in in the “OFF” mode af ter a power out, even when the power comes on
again.
Technical data:
Working Voltage for socket…………………………………..100V-127V~/60Hz
Transmission frequency…………………………………….. 433.92MHz
Max.load current……………………………....................... 10A
Power for transmitter………………………………………… DC12V battery
Detailed Learning Operation:
All remote controlled socket units have been pre-programmed and can be used immediately.
To re-program the remote control transmitter and socket receiver, please follow instructions below.
■ Plug the remote controlled socket to a power point and turn the power on.
■ Press and hold the learning button on the right and side of the socket receiver for about 5 seconds till the
LED indicator flashes.
■ Release the learning button and press the preferred “ on” or “off” number button of the transmitter.
■ Programming successful when the LED indicator stops flashing.
■ The remote controlled socket is now ready to use.
■ Remote set up only requires one-time programming.
●
Pls note: The transmitter with 12V 23A battery is ready for learning operation in advance. Keep one hand
press the Learning button on socket, the other hand holds the transmitter.
Change the battery:
Regularly ch ange the bat tery in the remote control for best u se – how ever if you find the receiver s are not
responding or the LED indicator of remote control becomes dim, then you must change the battery at the
earliest available time. Always dispose of old batteries with consideration for the environment.
NOTES:
●Make sure the battery and socket installation is firm, safe and correct.