User's Manual

2/2
Maximum motor load: 1/3hp
Maximum tungsten load: 1000W
Receiving Sensitivity -100dBm
SD-US1-RF parameter Battery: 27A 12VDC; Battery life: one year; remote control
distance: ≥20m；Sending sensitivity≥-25dBm
Controls up to 4 channels.
SD-US2-RF parameter Battery: 23A 12VDC; Battery life: one year; remote control
distance: ≥40m; Sending sensitivity≥-25dBm
Controls up to 20 channels.
Ⅳ
ⅣⅣ
Ⅳ、
、、
、Attention
1. Due to the fact the product produces some slight heat during the operation, it isn’t allowable
to put it onto some furniture or radiators, and to be covered by any blind, table cloth or any other
objects.
2. Don’t use it with an over loading electrical appliance.
3. The product must be properly connected to a grounded three-line receptacle
Reminding
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
NINGBO COMEN ELECTRONICS TECHNOLOGY CO.,LTD
ADD: NO.2 HONGXING ROAD,ZONE A HONGTANG INDUSTRY PARK,NINGBO,CHINA
TEL:[phone] FAX:[phone]
E-mail: [e-mail]
HTTP:
www.comen.com.cn