User's Manual
Product Outline
5. Speaker indicator light
4. Power switch
6. Micro USB-input
7. Wireless receiver
input posion
Caut ion and Safety
1. Do not use the charger if it is wet.
2.Do not use the charger in direct sunlight or high
temperatures.
This device complies with Part 15 of the FCC Rules. Operaon
is subject to the following two condions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operaon.
Warning:
Changes or modificaons not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Note:This equipment has been tested and found to comply
with the limits for a class B digital device,pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protecon against harmful interference in a
residenal installaon.
This equipment generates uses and can radiate radio
frequence energy and,if not installed and used in accordance
with the instrucons,may cause harmful interference to radio
communicaons.However,there is no guarantee that
interference will not accor in a parcular installaon.if this
equipmemt does cause harmful interference to radio or
television recepon,which can be determined by turning the
equipment off and on,the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different
from that to which the receiver is connectec.
• Consult the dealer or an experienced radio/TV technician for
help.
The device has been evaluated to meet general RF exposure
requirement. The devicecan be used in portable exposure
condion without restricon.
3. Do not place anything between the mobile device being
charged and the charging posion.
Charging Instruct
ions
1. Insert one end of USB charging cable into power adaptor
or computer.
2. Insert the other end of USB charging cable into Micro USB
port on the wireless charger .
3. Place your speaker on the wireless charging posion. Make
sure that the speaker is placed in the center of the charger.
The indicator light will light red
to indicate charging.
Product Specif icat ion
Speaker
Model: 2776
Output Power: 3W X 1
Frequency response: 20Hz-20KHz
Input: DC5V/180mA
Baery: 300 mAh
Transmission range: 10m
55mm
90mm
MADE IN CHINA
4
5
7
6
USER MANUAL
Bluetooth speaker
Bluetooth speaker operaon
1. Slide the power switch to ON posion
2. Open the Bluetooth in your phone, select” BT SPEAKER”,
It will pair with your phone automacally.
3. Play music
4. Slide the power switch to OFF posion when not using.
FCC STATEMENT
OFF
OFF
OFF