User's Manual

Product Outline
3. Micro USB input
1. Insert one end of USB charging cable into power adaptor or
computer.
2. Insert the other end of USB charging cable into Micro USB
port on the speaker.
3. The LED indicator light will light red to indicate charging
and turn off when fully charged.
Off
1. Hold down the Power Buon for 3 or more seconds to
turn on the speaker.
2. Open tBluetooth Sengs on your device, select” SP83”, it
will pair with your phone automacally.
3. Play music.
4. Hold down the Power Buon for 3 or more seconds to
turn off the speaker
Fan operaon
Short press the Fan control buon successively to switch the
Level and turn off : Level 1 Level 2 Level 3
SAFETY CAUTIONS:
2. Avoid touch with liquids; keep away from water.
3.
4.
Do not near heat sources such as radiators, heaters, air
ducts, or direct sunlight.
Do not hit the product severely or insert any conducve
objects into the speaker.
5. Stop using at once if the unit becomes hot, smokes, has a
burning smell, not-normal noise, or fire is noced coming from
product.
6. To avoid electrical shock. Do not touch product with wet
hand.
7. Keep out of reach of children.
FCC ID: 2ABHA0085
Product Specificaon
Model: SP83
Output Power: 3W
Frequency response: 20Hz-20KHz
Input: DC5V/1A
Transmission range: 10m
55mm
90mm
MADE IN CHINA
3
4
6
5
1
2
USER MANUAL
Fan Bluetooth speaker
FCC STATEMENT
4. LED indicator
5. Speaker
6. Fan
This device complies with Part 15 of the FCC Rules, operation is
subject to the following two conditions: (1) This device may not
cause harmful interference,and (2) this device must accept any
interference received,including interference that may cause
undesired operation.
• Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.