Users Manual

-- Fix the mounting bracket on the wall using the screws.
--
Align the spotlight into the desired direction by connecting the lamp with the mounting blacket.
When alignment, tighten the locking screws of the mounting blacket, to ensure a secure hold.
Setting the lighting duration
Turn the TIME rotary control on the bottom of the motion detector clockwise to increase the
duration of illumination. The lighting duration can be adjusted within a time window of approx.3
seconds(in the position-) to 7 minutes(in the position+).
Adjusting the sensitivity of the sensor
Turn the SENS rotary control on the bottom of the motion detector clockwise to increase the
sensitivity of the sensor
Note: The motion detector responds to heat radiation. When out- door temperatures are low, it is
more sensitive to body heat than when outdoor temperatures are warm. Be sure to regulate the
sensitivity of the sensor over the course of the year.
Note: Please observe that the motion detector primarily detects movements transverse to the
motion detector . If you move directly towards the motion detector, it cannot detect this
movement.
Setting the daylight level
Turn the LUX rotary control on the bottom side of the motion detector clockwise to increase the
daylight level: In the position , the motion detector only reacts at night (at approx. 20 lx). In
the position
, the motion detector also responds at daylight levels, as long as about 20,000 lx
are not exceeded.
Remote Control Operation
Control the whole lamp power by button (press the button, if there is a green indicator light
work it means the whole light power is on, no indication light work no power of the light )
, press
the button ON to turn on the lamp alarm function(in this time, the green indicator light will change
the green color into red, the light function and the alarm function will work together), press the
button OFF to turn off the alarm function(in this time, the indicator light will go back to green
color,the light function will still work).
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.