Assembly Instructions

2.7 Antennas
Module contains one PCB antenna. No additional external connectors.
2.8 Label and compliance information
The outside of final products that contains this
module device must display a label
referring to the enclosed module. This exterior label can use wording such as: “Contains
Transmitter Module FCC ID: 2AIWW-PD-V10-G5”,or “Contains
FCC ID: 2AIWW-PD-V10- G5 ”, Any similar wording that expresses the same meaning may
be used.
2.9 Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module grantee on the required
frequency , it should not be necessary for the host installer to re-test.
It is recommended that the host product manufacturer, installing the modular transmitter,
perform some investigative measurements to confirm that the resulting composite
system does not exceed the spurious emissions limits or band edge limits.
b) The testing should check for emissions that may occur due to the intermixing of
emissions with the other transmitters, digital circuitry, or due to physical properties of
the host product (enclosure). This investigation is especially important when integrating
multiple modular transmitters where the certification is based on testing each of them in
a stand-alone configuration. It is important to note that host product manufacturers
should not assume that because the modular transmitter is certified that they do not
have any responsibility for final product compliance.