Instruction Manual

• The outdoor values of the outdoor transmitter will be transmitted to the receiver. The displays of the
outdoor values are flashing "--.-".
• On the display of the receiver appear the channel number.
• If receiver receive the signal, it will display the current temperature of transmitter in OUT position.
• If the reception of the outdoor values fails within three minutes, "- -"appears on the display. Check the
batteries of the transmitter and try it again. Check if there is any source of interference.
• You can also start the outdoor transmitter search manually later on (for example when the outdoor
transmitter is lost or the batteries are changed).
• Hold the button on the receiver for three seconds, "---" blinking on the display.
• Press the TX button in the battery compartment of the outdoor transmitter.
• The receiver receives the values from the outdoor transmitter.
6.2.1 Reception of the outdoor values
-7-
• After successful installation close the battery compartment of the outdoor transmitter carefully.
6.3 Reception of the RCC frequency signal
• After the reception of the outdoor values, the device will now scan the RCC frequency signal and
the RCC symbol will be flashing on the display.
• To avoid interference, the other buttons (except ) will no function during the reception
of the radio controlled clock.
• When the time code is received successfully after 2-12 minutes, the radio-controlled time and the
RCC symbol are displayed steadily in the display. The other buttons are activated permanently.
• You can start the initialization manually.
• Press and hold the button for 3 seconds. The RCC symbol will be flashing.
• Interrupt the reception by pressing the button again. The RCC symbol disappears.