Instruction Manual

Please take note of the following:
• The recommended distance to any interfering sources like computer monitors or TV sets at least
1.5-2 meters.
• Inside ferro-concrete rooms (basements,superstructures),the received signal is naturally weakened.
In extreme cases, please place the unit close to a window to improve the reception.
• During night-time, the atmospheric interference is usually less severe and reception is possible in
most cases.A single daily reception is adequate to keep the accuracy deviation under 1 second.
• During the operation, all successful settings will be confirmed by a brief beep tone.
• The device will automatically quit the setting mode if no button is pressed for a long period of time.
• Press and hold the or button in the setting mode for fast running.
7.1 Manual settings
7. Operation
SET
AL SET
• Hold the button in normal mode for three seconds, to enter the setting mode.
• The setting sequence is shown as follows: Time Zone - DST on/off - 12 or 24 hours system
- Hour - Minute - Year - Month - Day - Language of week.
-9-
• Press the or button to increase or decrease for setting.
• Press and hold the or button for fast running.
• Confirm the setting with the button or no button pressed in 15 seconds.
• The manually set time will be overwritten by the RCC time when the signal is received successfully.
SET
AL SET
7.1.1 Setting of the time zone
• In the setting mode you can make the time zone.
• The time zone correction is needed for countries where the RCC signal can be received.