User's Manual

LED Surface Mounted Luminaire

Products model:

TOP8232-LED-U-X-Sensor-EM, TOPA224-LED-U-X-Sensor-EM

Note:"X" indicates CCT, between 2700K and 6500K

Safety instruction

1. Electrical works have to be done by technical persons.

2. Disconnect the lamp from the power supply and let the lamp cool down before

replacing the luminaire.

3. Never touch the luminaire when the power is on.

4. In case of damages, disconnect the lamp from the power supply. Do not try to

repair the lamp on your own. Repair has to be done by technical persons or

customer service.

Installation

PAGE 1
LED Surface Mounted Luminaire Products model: TOP8232-LED-U-X-Sensor-EM, TOPA224-LED-U-X-Sensor-EM Note:"X" indicates CCT, between 2700K and 6500K Safety instruction 1. Electrical works have to be done by technical persons. 2. Disconnect the lamp from the power supply and let the lamp cool down before replacing the luminaire. 3. Never touch the luminaire when the power is on. 4. In case of damages, disconnect the lamp from the power supply. Do not try to repair the lamp on your own.
PAGE 2
1. Drill the fitting holes at the place of installation (wall/ ceiling), make sure, that no cables or other lines are passing in place of drilling. 2. Put the screws in the holes and fix the lamp to the mounting place. 3. Insert the power cable (Type SJTW, 18AWG, min 80℃) connected to the connector, through the bushing in the opening . (By slightly pulling, the position of the washer can be optimised) 4.
PAGE 3
PAGE 4
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.