Installation Manual

3.
Align arrows on lid
and handle, then
lower handle to lock
in place.
1.
Place pitcher on
base and turn
clockwise to
lock in place.
2.
Holding the blade
assembly by the top
of the shaft, insert it
into the pitcher.
STACKED BLADE ASSEMBLY
Please make sure to read your Ninja Owner’s Guide in addition to this instruction sheet.
WARNING: Blades are sharp and not locked in place. Make sure lid is locked onto the
pitcher before pouring. If pouring without lid, ALWAYS remove blades first. Failure
to do so will result in a laceration risk. Refer to the Ninja Owner’s Guide for additional
information.
ASSEMBLY
QUESTIONS? We’re here to help. Call 1-877-646-5288 or visit www.ninjakitchen.com
CLEANING
Hand washing: Wash the lid, pitcher and blade assembly in
warm, soapy water. When washing the blade assembly, use
a dish washing utensil with a handle to avoid direct hand
contact with blades. Handle blade assembly with care to
avoid contact with sharp edges, rinse and air dry thoroughly.
WARNING: Handle the Stacked Blade Assembly with
care when washing, as the blades are sharp. Contact with
the blade’s edge can result in laceration.
Dishwasher: The pitcher, lid and Stacked Blade Assembly
are all dishwasher safe. It is recommended that the lid and
blade assembly be placed on the top rack. Ensure that the
blade assembly is removed from the pitcher before placing
in the dishwasher.
WARNING: Stacked
Blade Assembly is
sharp and not locked in
place. If using the pour
spout, ensure the lid is
fully locked onto the
blender pitcher. Failure
to do so will result in a
risk of laceration.
WARNING: Stacked
Blade Assembly is sharp
and not locked in place.
If pouring with the lid
removed, carefully
remove the Stacked Blade
Assembly first holding it
by the shaft. Failure to do
so will result in a risk of
laceration.