Use and Care Manual

6
www.ninjakitchen.com
Fig. 3b
Fig. 1
Assembly and Use for the Blender Pitcher
1 Place the motor base on a clean, dry, level surface
such as a counter or table top.
2 Align and lower the Pitcher onto the motor base.
(Fig. 1) Handle should be aligned slightly to the right of
the “LOCK” symbol on the motor base.
3 Rotate the pitcher clockwise until it locks in place. You
will hear a click when the lock is engaged. (Fig. 2)
4 The pitcher can be placed on the motor base two ways;
the handle can be on the front right corner or the front
left corner. (Fig. 3a, Fig. 3b)
5 Holding the 6-Blade Assembly by the top of the shaft,
place it onto the drive gear inside the pitcher. Ensure
that the attachment is seated properly and is standing
upright. (Fig. 4)
NOTE: The blade will fit loosely on the drive gear.
6 Add the ingredients to the pitcher, making sure that
they do not exceed the highest measured marking line
on the side of the pitcher.
NOTE: If you need to add additional ingredients while
the appliance is processing, open the pour spout cap
and pour the ingredients in through the opening.
NOTE: When blending any kind of liquids, such as
mixtures of any drinks or smoothies, do not exceed the
“Max liquid” mark (64 ounces) on the pitcher.
7 Plug the power cord into the electrical outlet and press
the power button (
).
IMPORTANT: As a safety feature, the power
button (
) will flash and the motor will not work
if the pitcher and lid are not installed correctly.
When the pitcher and lid are installed properly,
the power button ( ) will be solid, indicating that
the appliance is ready for use.
8 Holding the lid by the handle in the upright position,
place it on top of the pitcher aligning the arrow (
)
located on the lid with the arrow ( ) located on the
pitcher’s handle. (Fig. 5) Press the handle down until
you hear a click.
Fig. 4
Fig. 5
ASSEMBLY
Fig. 3a
WARNING: Never leave the appliance unattended while in use.
CAUTION: Handle the blade assemblies with care, as the blades are very sharp.
IMPORTANT: Make sure that the motor base is plugged in for use.
Fig. 2