User Guide

ManualsBrandsNinja ManualsAppliancesCoffee Bar Single-Serve System

For how-to videos and more, visit ninjacoffeebar.com | Questions? 1-877-646-5288

2. Hold the cup under the

frother and submerge

the whisk just below the

surface of the milk. Froth

for 30–45 seconds.

3. Remove the frother whisk

by twisting clockwise. Keep

your cup below the whisk while

you carry it to your sink or

dishwasher for easy cleaning.

For how-to videos and more, visit ninjacoffeebar.com | Questions? 1-877-646-5288

CF110 SERIES

Please make sure to read the enclosed Ninja

Owner’s Guide prior to using your unit.

FILLING THE WATER RESERVOIR

For how-to videos and more, visit ninjacoffeebar.com | Questions? 1-877-646-5288

BEFORE YOUR

FIRST BREW

Before ﬁrst use, plug in your brewer

and run two Multi-Serve Clean cycles.

With your water reservoir ﬁlled to the

max line with fresh water, your brewer

plugged in, and a 22 oz. or larger

container in place, press the CLEAN

button to start a cycle.

(Discard the brewed water after each cleaning cycle.)

FILL TO THE MAX LINE.

Let Auto-iQ

™

take it from there.

The water reservoir lid is removable for

easy cleaning and is dishwasher safe.

REMOVABLE BREW BASKET

FOR EASY CLEANUP

To avoid spills and drips, keep the

ﬁlter inside the removable brew

basket as you carry it to the trash.

STOP THE DRIPS AFTER THE BREW

At the end of a brew, close the drip

stop to prevent drops of coffee

from escaping.

DRIP STOP CLEANUP

QUICK START

GUIDE

HOT OR COLD FROTHING AT YOUR FINGERTIPS

CAUTION: DO NOT reach across top of brewer to froth during brewing. Steam is released from vent on top of

brewer and can result in a steam burn.

1. Add milk to your cup

until it is about

⁄3 full.

For hot froth, microwave for

45–60 seconds.

For cold froth, skip to Step 2.

FOR HOT FROTH

PLUG IN, POWER UP, AND PRE-HEAT

Plug in your brewer, then press the power

button. The PRE-HEATING light will

illuminate for 3 minutes.

When the light goes out,

you’re ready to brew some

steaming hot coffee.

PRE-HEAT FOR THE HOTTEST FIRST CUP

PRE- HEATING

Pre-heating ensures

your ﬁrst cup will

be as hot as it

possibly can be.

(But if you don’t

have time to wait,

you can still brew

before pre-heat is

fully activated.)

Summary of content (2 pages)

PAGE 1
CF110 SERIES Please make sure to read the enclosed Ninja Owner’s Guide prior to using your unit. ® HOT OR COLD FROTHING AT YOUR FINGERTIPS QUICK START GUIDE 1 FOR HOT FROTH 1. Add milk to your cup until it is about 1⁄3 full. For cold froth, skip to Step 2. BEFORE YOUR FIRST BREW Before first use, plug in your brewer For hot froth, microwave for 45–60 seconds. 2. H old the cup under the frother and submerge the whisk just below the surface of the milk. Froth for 30–45 seconds.
PAGE 2
3 4 POSITIONING YOUR CUP OR MUG CHOOSE YOUR FILTER 5 THE BREWING PROCESS—4 EASY STEPS HOW TO BREW CLASSIC, RICH, OR OVER ICE CUP 1 2 CHOOSE A SCOOP 3 CHOOSE A SIZE 4 CHOOSE A BREW Simply press your desired brew type button and the brew will begin. CLASSIC Smooth, wellbalanced flavor. Pull the handle to swing the brew basket open. RICH Richer than classic with more intense flavor that really stands up to milk, cream, or flavoring.