CFP200 Series GROUNDS & PODS DualBrew OWNER’S GUIDE COFFEE MAKER ninjakitchen.
THANK YOU for purchasing the Ninja® DualBrew Coffee Maker CONTENTS Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Using the Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Smart Sensing Mode Indicators . . . . . . . . . . .
IMPORTANT SAFEGUARDS READ ALL INSTRUCTIONS BEFORE USE • HOUSEHOLD USE ONLY Read all instructions before using your NINJA DUALBREW COFFEE MAKER When using electrical appliances, basic safety precautions should always be followed, including the following: WARNING To reduce the risk of fire, electric shock, serious injury, death, or damage when using this appliance, follow these basic safety precautions.
PARTS A Brewer (Power cord not shown) B 60 oz. Removable Water Reservoir C Removable Water Reservoir Lid D Sliding Lid J E Hinged Hood F Water Reservoir Base G Single-Serve Cup Platform K H Control Panel I Brew Basket j Ninja Pod Adapter K Brew-Through Lid L Ninja Glass Carafe M Ninja Smart Scoop™ O Intelligent Warming Plate P Drip Stop Q Hot Water Dial (not available on all models) L I E C A D B H Q P G M F O 4 1-877-646-5288 ninjakitchen.
USING THE CONTROL PANEL PREPARING FOR USE 11 12 SETTING THE CLOCK When the brewer is first plugged in, the time will need to be set. 13 10 1 1 Press the HR/MIN button to set the clock. 2 Use the Multi-Serve Dial to select the correct hour. Then, press the START BREW button to toggle to minutes. Use the dial again to select the correct minute, and press the START BREW button to set the clock at the displayed time.
PRIMING YOUR NINJA® DUALBREW COFFEE MAKER 1 Clean all accessories before your first brew. 2 Plug the brewer in and turn it on by pressing the power button. 3 Lift the water reservoir off of its base. Remove the reservoir lid. Add water up to, but not exceeding the Full line. Return the water reservoir to the brewer. DO NOT fill the water reservoir with anything other than water, as other liquids may damage your brewer. NOTE: We recommend using cool or room temperature water in the reservoir.
USING THE NINJA® DUALBREW COFFEE MAKER CONT. MEASURING YOUR COFFEE GROUNDS For best results, use the measurements on the Ninja Smart Scoop™ or in the chart to determine how much ground coffee to use for each brew size. Always use level scoops when measuring ground coffee. The amount of ground coffee for each size will remain the same for any brew type you select. For example, if you select Cup and Classic, you will use the same amount of coffee grounds as if you were to select Cup and Over Ice.
USING THE NINJA® DUALBREW COFFEE MAKER CONT. 2 Ensure the adapter is in the REMOVE position before installing. Then place the adapter over the brew basket and push down firmly so it is fully seated. 5 Press the handle down firmly to pierce the pod, and ensure that it is completely closed. There will be an audible click and some resistance when closing the handle as the needles puncture the pod. NOTE: DO NOT remove the top of the K-Cup Pod.
USING THE NINJA® DUALBREW COFFEE MAKER CONT. INTELLIGENT WARMING PLATE The Intelligent Warming Plate will automatically turn on during Classic or Rich brews when a 1/4, 1/2, 3/4, or full carafe size is selected. The Intelligent Warming Plate is set to a specific temperature setpoint to avoid burning the coffee over time. To turn the warming plate on at any time, turn the dial to one of the carafe sizes, select Classic or Rich, and press the KEEP WARM button.
USING THE NINJA® DUALBREW COFFEE MAKER CONT. CLEANING & MAINTENANCE DISPENSING HOT WATER CLEANING AFTER A BREW CLEANING THE NINJA POD ADAPTER 1 After the brewer has cooled, remove the brew basket. If using pods, remove the Ninja Pod Adapter and brew basket. Wash the used parts thoroughly with soap and warm water. Open the handle to reveal the needles and pod holder and hand-wash with warm, soapy water. Take care when cleaning around the needles.
CLEANING & MAINTENANCE CONT. CHOOSING WHICH MODE TO CLEAN When the Intelligent Clean Cycle Indicator turns on for the first time, run a clean cycle on the mode you use most. For example, if you primarily brew with grounds, run the clean cycle on the Grounds mode with the Sliding Lid closed. If you primarily use pods, ensure the Ninja Pod Adapter is installed, and run the clean cycle through the Ninja Pod Adapter.
TROUBLESHOOTING GUIDE CONT. Brewer is not detecting the Ninja® Pod Adapter. •E nsure the adapter is fully seated in place over the brew basket with the handle closed. Pull the handle toward you until it clicks into the LOCK position. Refer to pages 11 and 12 for more information. • Ensure the Hot Water Dial (not available on all models) is turned completely to the coffee bean icon. Coffee is splattering. •S ome splatter is normal.
SharkNinja Operating LLC US: Needham, MA 02494 1-877-646-5288 ninjakitchen.com Illustrations may differ from actual product. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice. NINJA is a registered trademark of SharkNinja Operating LLC. NINJA SMART SCOOP is a trademark of SharkNinja Operating LLC. K-CUP is a registered trademark of Keurig Green Mountain, Inc.