User Guide

INGREDIENTS
1 tablespoon (18 g) cream cheese
70 g granulated sugar
180 ml heavy cream
Flavoring, 1 teaspoon extract of your choice
OR 2 tablespoons of cocoa powder
240 ml whole milk
40 g of your favorite mix-ins (optional)
PICK YOUR MIX-INS TO ADD A PERSONAL TOUCH
Perfectly personalized ice cream
PREP: 5 minutes | FREEZE: 24 hours | PROGRAM TIME: 1
1
/2 minutes | MAKES: 4 servings
Microwave the cream
cheese for 10 seconds.
Add sugar and flavor,
then whisk the mixture
until it looks like frosting.
Slowly mix in heavy
cream and milk until
sugar is dissolved.
Pour base into
CREAMi™ Pint. Place
lid on pint and freeze
for 24 hours.
Remove lid from
frozen pint.
Refer to next page for
Assembly & Process
instructions.
Select ICE CREAM.
With a spoon, create a 4 cm
wide hole that reaches the
bottom of the pint.
Add mix-ins to the hole in the
pint and process again using
the MIX-IN program.
40 g of your favorite crushed candies, frozen fruits, chopped nuts,
chocolate pieces, and more.
PICK YOUR FLAVOR
Vanilla extractCocoa powder Mint extract Fruit extractAlmond extract
2.
Install
CREAMi™ Pint
Remove lid from pint and
check that the ingredients
have not been frozen at
an angle. Place the pint
containing the frozen
base in the outer bowl.
4.
Install lid
Position the tab of the
lid just slightly to the
right of the outer bowl
handle so the lines
on the lid and handle
align. Rotate the lid
clockwise to lock.
Assembly & Process
5.
Install outer bowl
After plugging in the unit, place
the outer bowl on the base with the
handle in the middle of the unit.
Twist handle to the right to raise
the platform and lock the bowl in
place. You should hear a click.
1.
Plug in unit first
The unit will NOT run
if the outer bowl is
installed before the
unit is plugged in.
6.
Select program
Press the power button,
then select the program
that suits your recipe.
7.
Remove bowl
When program ends, hold the
release button on the left of
the motor base and twist bowl
handle clockwise to remove.
8.
Remove lid
Press the lid unlock
button and twist
to remove lid.
Bowl Release
Button
To remove the
outer bowl, hold
release button.
If adding mix-ins, use
a spoon to create a 4 cm
wide hole that reaches
the bottom of the pint.
Add chopped or broken
mix-ins to the hole in the
pint and process again
using the MIX-IN program.
If not adding mix-ins,
RE-SPIN can be used on
a crumbly or powdery
pint to make it creamy.
RE-SPIN is often needed
for very cold bases.
DO NOT RE-SPIN before
using MIX-IN program.
OR
If programs will not illuminate, make sure the unit is properly assembled.
See the troubleshooting section of the safety instructions if install light is illuminated.
NOTE
SCAN & WATCH
HOW IT WORKS
qr.ninjakitchen.com/
creami-ca
MAKE IT DAIRY-FREE Use vegan cream cheese for cream cheese, unsweetened coconut cream
for heavy cream, and unsweetened oat milk for milk. Whisk the coconut cream until smooth,
then add the remaining ingredients.
9.
3.
Install
Creamerizer™ Paddle
Press and hold the paddle
latch on the top of the outer
bowl lid, then insert the
paddle in the bottom of
the lid. Release the latch
to secure the paddle.