Operation Manual
1
WHEN USING THE CIRCLE PAD PRO ACCESSORY:
1. Be sure to close the Nintendo 3DS XL system when attaching it or removing it from the Circle
Pad Pro. Holding the upper screen during this procedure may damage the system.
2. Do not apply excessive force when using the Circle Pad. Doing so may damage the system.
WARNING – Battery Leakage
Leakage of battery uid can cause personal injury as well as damage to your accessory. If battery
leakage occurs, thoroughly wash the aected skin and clothes. Keep battery uid away from your
eyes and mouth. Leaking batteries may make popping sounds. To avoid battery leakage:
• Nintendo recommends alkaline batteries. Do not use Lithium-ion, nickel-cadmium (NiCad),
or carbon-zinc batteries.
• Do not leave the battery in the accessory for long periods of non-use.
• Do not recharge alkaline or non-rechargeable batteries.
• Do not put the battery in backwards. Make sure that the positive (+) and negative (-) ends
are facing in the correct directions. Insert the negative end rst. When removing the battery,
remove the positive end rst.
• Do not use a damaged, deformed, or leaking battery.
• Do not dispose of batteries in a re.
• When disposing of batteries, take care to follow appropriate local guidelines and regulations.
Infrared transceiver
Battery cover
Right Circle Pad
R Button
ZL Button
ZR Button
Trademarks are property of their respective owners. Nintendo 3DS is a trademark of Nintendo. © 2012 Nintendo.
1. Circle Pad Pro components
2. Battery installation
NOTE: An adult should assist with this procedure if a child will be using the accessory.
The Circle Pad Pro accessory uses a single AAA battery (included). Nintendo recommends using
a high-quality alkaline battery for best performance and maximum battery life. If you use re-
chargeable nickel metal hydride (NiMH) batteries, be sure to follow the manufacturer’s
guidelines for safety and proper usage.
Battery life is approximately 480 hours, depending on the type of software being used and usage
conditions such as the ambient temperature.
Using a coin or at head screwdriver, loosen the screw and remove the battery cover.
Insert a AAA battery, negative ( ) end rst,
as shown in the illustration.
When removing the battery, remove the
positive ( ) end rst.
Replace the battery cover and tighten the screw.