Owner's Manual

BLOWER MOTOR
MTC-47
C
D
E
F
G
H
I
K
L
M
A
B
MTC
2. CHECK POWER SUPPLY FOR BLOWER MOTOR
1. Disconnect blower motor harness connector.
2. Do approx. 12 volts exist between blower motor harness terminal + and body ground?
Yes or No
Yes >> GO TO 3.
No >> Check 15A (Nos. 14 and 16) fuses at fuse block. Refer to PG-9, "
IGNITION POWER SUPPLY —
IGNITION SW. IN “ON”" .
3. CHECK CIRCUIT CONTINUITY FOR BLOWER MOTOR
1. Turn fan control switch to any position except OFF.
2. Check circuit continuity between blower motor connector M57
terminal – (L/B) and body ground.
OK or NG
OK >> GO TO 4.
NG >> Reconnect blower motor harness connector. GO TO 5.
4. CHECK BLOWER MOTOR
Refer to MTC-50, "
BLOWER MOTOR" .
OK or NG
OK >> INSPECTION END.
NG >> Replace blower motor.
LHA137
Continuity should exist.
WJIA0005E