Owner's Manual

COMPRESSOR CLUTCH
MTC-71
C
D
E
F
G
H
I
K
L
M
A
B
MTC
QR25DE
● When removing center bolt, hold clutch disc with clutch disc tool.
● Remove the drive plate using the clutch disc puller.
Insert the holder's three pins into the drive plate. Rotate the
holder clockwise to hook it onto the plate. Then tighten the cen-
ter bolt to remove the drive plate.
While tightening the center bolt, insert a round bar (screwdriver,
etc.) between two of the pins (as shown in the figure) to prevent
drive plate rotation. After removing the drive plate, remove the
shims from either the drive shaft or the drive plate.
● Remove the snap ring using external snap ring pliers.
● For pulley removal, use pulley puller.
Use a commercially available pulley puller. Position the center
of the puller on the end of the drive shaft. Remove the pulley
assembly with the puller.
To prevent deformation of the pulley groove, the puller
claws should be hooked under (not into) the pulley groove.
● Remove the field coil harness clip using a screwdriver.
AHA841
AHA506A
AHA843
RHA139E