Owner's Manual

MTC-72
COMPRESSOR CLUTCH
● Remove the three field coil fixing screws and remove the field
coil.
Inspection EJS001BG
CLUTCH DISC
If the contact surface shows signs of damage due to excessive heat,
replace clutch disc and pulley.
PULLEY
Check the appearance of the pulley assembly. If contact surface of pulley shows signs of excessive grooving,
replace clutch disc and pulley. The contact surfaces of the pulley assembly should be cleaned with a suitable
solvent before reinstallation.
COIL
Check magnet coil for loose connection or cracked insulation.
Installation EJS001BH
QG18DE
● Install the magnet coil.
Be sure to align the magnet coil pin with the hole in the
compressor front head.
● Install the magnet coil harness clip using a screwdriver.
● Install the pulley assembly using the installer and a wrench, and
then install the snap ring using snap ring pliers.
RHA074C
WHA183
WHA213
WJIA0368E