Owner's Manual
MTC-74
COMPRESSOR CLUTCH
QR25DE
● Install the field coil.
Be sure to align the magnet coil pin with the hole in the
compressor front head.
● Install the magnet coil harness clip using a screwdriver.
● Install the pulley assembly using the installer, and then install the
snap ring using snap ring pliers.
● Install the drive plate on the drive shaft, together with the original
shim(s). Press the drive plate down with the installer.
● Using the holder to prevent clutch disc rotation, tighten the bolt
to 12 to 15 N-m (1.2 to 1.5 kg-m, 9 to 11 ft-lb) torque.
● After tightening the bolt, check that the pulley rotates
smoothly.
RHA076C
WJIA0368E
RHA078C
AHA847