Owner's Manual

BLOWER UNIT
MTC-79
C
D
E
F
G
H
I
K
L
M
A
B
MTC
BLOWER UNIT PFP:27200
Removal EJS001BM
1. Discharge the A/C system. Refer to MTC-82, "Discharging
Refrigerant" .
2. Disconnect the two refrigerant lines from the engine compart-
ment.
Cap the A/C lines to prevent moisture from entering the system.
3. Remove the glove box and mating trim. Refer to IP-10,
"Removal and Installation" .
4. Remove cooling unit. Refer to MTC-80, "
Removal" .
5. Disconnect the resistor and blower motor connector.
6. Remove blower unit.
7. Remove the three bolts and then remove the motor from the
blower case.
Installation EJS001BN
Install in the reverse order of removal.
Recharge the A/C system. Refer to MTC-82, "
Evacuating System and Charging Refrigerant" .
LHA204
LHA130