Owner's Manual

A/C EVAPORATOR
MTC-81
C
D
E
F
G
H
I
K
L
M
A
B
MTC
13. Mark installation point of intake sensor and remove intake sen-
sor from evaporator core.
14. Remove evaporator core from case by sliding forward off of
case retaining tabs.
15. Remove expansion valve from evaporator core (if necessary).
Installation EJS001BP
Installation is the reverse of removal*.
Recharge the A/C system. Refer to MTC-82, "
Evacuating System and Charging Refrigerant" .
*: When installing lower cover to cooling unit case, ensure that the thermo probe is in the same location as
originally installed, and that the intake sensor wire is properly positioned in case slot.
NOTE:
Be sure that the evaporator core is fully seated against the dash panel before securing lower cover.
WJIA0254E