Owner's Manual

MT-102
[RS6F51H]
INPUT SHAFT AND GEARS
9. Remove the 5th bushing, thrust washer, 4th input gear, 4th nee-
dle bearing, 4th bushing, 4th baulk ring, 3rd-4th synchronizer
hub assembly, 3rd baulk ring, and 3rd input gear simultaneously
using Tool as shown.
10. Remove the 3rd needle bearing.
11. Remove the input shaft front bearing using Tool as shown.
INSPECTION AFTER DISASSEMBLY
Input Shaft and Gear
Inspect the components for the following conditions as shown. If
necessary, replace them with new ones.
● Damage, peeling, dent, uneven wear, or bending of the input
shaft.
● Excessive wear, damage, or peeling of the input gears.
Synchronizer
Check the items below. If necessary, replace them with new ones.
● Damage and excessive wear of the contact surfaces of coupling
sleeve, synchronizer hub, and shifting insert.
● Coupling sleeve and synchronizer hub must move smoothly as
shown.
SCIA1030E
SCIA0920E
SMT636A
SMT387A