Owner's Manual

INPUT SHAFT AND GEARS
MT-103
[RS6F51H]
D
E
F
G
H
I
J
K
L
M
A
B
MT
● If any cracks, damage, or excessive wear is found on the cam
face of baulk ring or working face of the insert as shown, replace
it.
Baulk ring clearance
Press the baulk ring against cone, and measure clearance between
baulk ring and cone. If measurement is below limit, replace it with a
new one.
Bearing
Check the items below. If necessary, replace them with new ones.
● Rough rotation of the bearing as shown.
● Damage to the bearing.
ASSEMBLY
1. Install the 3rd needle bearing.
2. Install the 3rd input gear and 3rd baulk ring.
3. Install the spread spring, shifting insert, and a new 3rd-4th synchronizer hub onto the 3rd-4th coupling
sleeve.
CAUTION:
Do not reuse the 3rd-4th synchronizer hub.
● Install with orientation of the synchronizer hub as shown.
SMT867D
Clearance - standard
3rd and 4th : 0.9 - 1.45 mm (0.035 - 0.0571 in)
5th and 6th : 0.95 - 1.4 mm (0.0374 - 0.055 in)
Limit : 0.7 mm (0.028 in)
SMT140
MTF0041D
SCIA0921E