Owner's Manual

MAINSHAFT AND GEARS
MT-111
[RS6F51H]
D
E
F
G
H
I
J
K
L
M
A
B
MT
3. Press the baulk ring on to the clutch gear taper cone by hand,
then measure the clearance “A” at two or more points diagonally
opposite with a feeler gauge, and then calculate the mean value.
4. Measure clearances “B” at two or more points diagonally oppo-
site with a feeler gauge, and then calculate the mean value.
5. Press the baulk ring on to the clutch gear taper cone by hand,
then measure the clearance “C” at two or more points diagonally
opposite with a feeler gauge, and then calculate the mean value.
Bearing
Check the items below. If necessary, replace them with new ones.
● Rough rotation of the bearing as shown.
● Damage to the bearing.
Clearance “A”
Standard : 0.6 - 1.2 mm (0.024 - 0.047 in)
Limit : 0.3 mm (0.012 in)
LCIA0298E
Clearance “B”
Standard : 0.6 - 1.1 mm (0.024 - 0.043 in)
Limit : 0.2 mm (0.008 in)
SCIA1084E
Clearance “C”
Standard : 0.7 - 1.1 mm (0.028 - 0.043 in)
Limit : 0.3 mm (0.012 in)
LCIA0300E
MTF0041D