Owner's Manual
MT-118
[RS6F51H]
REVERSE IDLER SHAFT AND GEARS
Baulk ring clearance
● Press the baulk ring against the cone, and measure the clear-
ance between the baulk ring and cone as shown. If the mea-
surement is below the specified limit, replace it with a new one.
Bearing
Check the parts listed. If necessary, replace them with new ones.
● Damage and rough rotation of the bearing.
ASSEMBLY
Assembly is in the reverse order of disassembly.
CAUTION:
● Install the insert spring with the orientation as shown.
Baulk ring to gear clearance
Standard : 0.95 - 1.4 mm (0.0374 - 0.055 in)
Limit value : 0.7 mm (0.028 in)
SMT140
SCIA0954E